Search
Now showing items 31-40 of 330
To study a design of two and three-plate mould for injection moulding process
(Universiti Malaysia Perlis, 2008-04)
The purpose of this project to learn and practice design guideline for plastic
injection moulding process in design mould. There include to understand all the factor
that will affect the design product example poor design ...
High speed downlink packet access (HSDPA)
(Universiti Malaysia Perlis, 2008-04)
The increasing demand for capacity in order to provide high data rate multimedia services in wireless environments necessitates enhanced radio transmission techniques and network protocol functionality. Such techniques ...
The influence of welding parameters and corrosive environment on the joint strength of resistance spot-welded mild steel sheets
(Universiti Malaysia Perlis, 2008-04)
In the present work, mild steel sheets consisting two batches were welded by resistance spot welding at different welding parameters and exposed under different environments. The 5% sodium chloride brine was used in the ...
The effect of pollution production in gas burner combustion system using Flat Vane Radial Air Swirler
(Universiti Malaysia Perlis, 2008-04)
A gas burner system with flat vane radial air swirler with vane angle of 20°, 40°
and 60° has been investigated to compare which swirler produce less Carbon Monoxide.
All tests were conducted using Butane gas. Fuel was ...
Influence of H2C204 solution on formation of Porous AAO thin film
(Universiti Malaysia Perlis, 2008-04)
The anodizing of aluminium has been investigated with the aim to realize nano-porous structures and nano-porous oxides for use as nano-templates. Before undergoing
electrochemical oxidation, aluminium samples were cleaned ...
Production of particle board from banana leaves
(Universiti Malaysia Perlis, 2008-06)
The method of agricultural waste disposal involving open burning which often to be used
by the banana plantations entrepreneur is unpractical where it is contribute to air pollution. Base on the situation above, this study ...
Corrosion study on welded mild steel in soil environment
(Universiti Malaysia Perlis, 2008-03)
This study was carried out to determine the corrosion behavior of welded mild steel in soil environment. The welding process was done by arc welding method at 70, 80, 90, 100 and 110 ampere. The corrosion behavior of welded ...
Simulation of Orthogonal Frequency Division Multiplexing (OFDM) signaling
(Universiti Malaysia Perlis, 2008-04)
The increasing demand on high bit rate and reliable wireless system has led to many new emerging modulation techniques. One of the techniques will be Orthogonal Frequency
Division Multiplexing (OFDM), which is combination ...
Recovery of Copper (Cu) from printed circuit board (PCB) using LAKOS separator
(Universiti Malaysia Perlis, 2008-04)
Printed Circuit Board (PCB) scrap has a metal content of nearly 28%, including an abundance of nonferrous metals such as copper, lead and tin. The purity of precious
metals in PCBs is more than 10 times that of content-rich ...
Synthesis and characterization of Fe-Al alloy with different sintering temperature
(Universiti Malaysia Perlis, 2008-04)
The iron aluminides Fe3Al and FeAl3 have been among the most widely studied intermetallics because of their low cost, low density, good wear resistance, ease of
fabrication and resistance to oxidation and corrosion. A ...