Search
Now showing items 1-10 of 16
The effects of multiple zincation process on Aluminum Bond Pad surface for Electroless Nickel Immersion Gold deposition
(American Society of Mechanical Engineers (ASME), 2006-09)
This paper reports the effects of a multiple zincation processon the Al bond pad surface prior to electroless nickel immersion gold deposition. The study of multiple zincation comprises the surface topogtaphy and morphology ...
Effect of alignment mark architecture on alignment signal behavior in advanced lithography
(Universiti Malaya, 2007)
Alignment mark architecture is divided into two types, which depending on where the mark is defined. Alignment mark that is defined through the contact masking steps is known as contact mark and alignment mark that is ...
Nanowire formation for single electron transistor using SEM based Electron Beam Lithography (EBL) technique: Positive tone vs negative tone e-beam resist
(Nano Science and Technology Institute, 2006)
Experimental studies of nanowires formation are carried out by using Scanning Electron Microscope Based Electron Beam Lithography (EBL) Technique with critical dimensions in less than 100nm. In order to complete the design ...
Nano patterning of cone dots and nano constrictions of negative e-beam resist for single electron transistor fabrication
(Springer New York, 2007-12)
We present an optimization of nano dot of negative tone e-beam resist which is a very important step in single electron transistor fabrication process. The optimum design of dot and nano constriction plays a significant ...
Designing of masks for quantum dot single electron transistor fabrication using E-beam nanolithography
(Nano Science and Technology Institute, 2007)
Quantum dot single electron transistor (QD SET) is able to be fabricated through a joint technique of e-beam lithography (EBL), pattern dependent oxidation (PADOX) and high density plasma etching. In this research, we have ...
Reproducibility of silicon single electron quantum dot transistor
(Nano Science and Technology Institute, 2006)
In principle, based on the form of tunnel junction, single electron transistor (SET) can be classified into four types, i.e. nanowire SET, quantum dot SET, nanotube SET and point contact SET. Another classification is SET ...
Borophosphosilicate glass (BPSG) reflow characterization for submicron CMOS technology
(Universiti Kebangsaan Malaysia, 2007)
This paper involves the planarization of borophosphosilicate glass (BPSG) film using a new recipe for annealing process to improve the borophosphosilicate glass (BPSG) film flatness after reflow. This improvement is for ...
Fabrication and characterization of Si quantum dots and SiO2 tunnel barriers grown by a controlled oxidation process
(IOP Publishing Ltd, 2008-01-29)
The control of the growth of silicon dioxide (SiO2) and the formation of quantum dots (QDs) play an important role in the fabrication of single-electron transistors (SETs). In this work, SET structures were fabricated using ...
An estimation of the energy and exergy efficiencies for the energy resources consumption in the transportation sector in Malaysia
(Elsevier Ltd., 2007-08)
The purpose of this work is to apply the useful energy and exergy analysis models for different modes of transport in Malaysia and to compare the result with a few countries. In this paper, energy and exergy efficiencies ...
The characterization of power supply noise for optical mouse sensor
(Institute of Electrical and Electronics Engineering (IEEE), 2006)
The induced power supply noise (sinusoidal waveform) that injected to Vdd pin will cause unwanted spike at the positive amplitude and negative amplitude to the DC input voltage. At certain limit this spike will cause the ...