Search
Now showing items 11-20 of 36
Mask design and fabrication of Micro/Nanowire biochip for reliable and repeatability pattern transfer
(Trans Tech Publications, 2014)
In Micro/Nanowire fabrication, the alignment and exposure process are the most critical steps in photolithography process, and indeed for the whole biochip processing. This process determines the success of transferring ...
Low cost detection of pH and its effect on the capacitive behavior of micro-gap sensor
(Trans Tech Publications, 2014)
The article describes the fabrication and characterization of silver microgap sensor on silicon substrate. By employing cheap photolithography process the proposed microgap sensor has been fabricated. The silver microgap ...
Conventional photolithography and process optimization of pattern- size expansion technique for nanogap biosensor fabrication
(Trans Tech Publications, 2014)
For a submicron photolithography process, there is little room for error. In this paper, an optimized technique for photoresist (PR) development is reported, to fabricate a nanogap biosensor for application in biomedical ...
Fabrication of nanostructure based biosensor for biomolecules detection
(Trans Tech Publications, 2014)
Lately, nanostructure based biosensor application has drawn a lot attention among fellow researchers because of speciality to detecting cell, tissue and even disease caused by viruses either from humans, animals or ...
Fabrication of silicon nanowires by electron beam lithography and thermal oxidation size reduction method
(Trans Tech Publications, 2014)
A simple method for the fabrication of silicon nanowires using Electron Beam Lithography (EBL) combined with thermal oxidation size reduction method is presented. EBL is used to define the initial silicon nanowires of ...
Reviewed immunosensor format using nanomaterial for tungro virus detection
(Trans Tech Publications, 2014)
Recently, nanomaterial based biosensor application has drawn a lot attention among researchers because of specialty to enhance the sensor signal for increasing the sensitivity for detecting and identification of pathogen, ...
Fabrication and characterization of IDE based sensor through conventional lithography method
(Trans Tech Publications, 2014)
This paper mainly illustrate regarding the fabrication process of IDE based sensor for bio-molecular detection process. Material that is utilized in this process is zinc oxide due to bio-compability and elevated electrical ...
Surface tension analysis of cost-effective paraffin wax and water flow simulation for microfluidic device
(Trans Tech Publications, 2014)
In microfluidic devices, the most important aspect has to be considered for the manufacturing process is the material suitability and geometric design. Among the materials studied, paraffin wax has never been tested and ...
Analysis of capillary filling in micro channels for passive fluid dynamics in Nano lab on chip domain
(Trans Tech Publications, 2014)
A fluid dynamics in a micro channel for analytical chemistry and different aspects of this type of flow for specific application has remained a long-acting problem in the last two decades considering its numerus applications ...
Review on Malaysian and Thailand's perspective towards renewable energy
(Trans Tech Publications, 2014)
This paper presents a review on Malaysia and Thailand’s view on renewable energy mainly in the area of solar energy. It is based on a survey conducted on random subjects in Malaysia raging from different discipline such ...