Search
Now showing items 41-50 of 350
Effect of anodizing voltage on the morphology and growth kinetics of porous anodic alumina on Al-0.5 wt% Mn alloys
(Trans Tech Publications, 2014)
In this study, the effect of anodizing voltage on the morphology of porous anodic alumina and growth kinetics of anodizing of aluminium manganese alloy was reported. It was found that the increasing anodizing voltage affect ...
The state of the arts: Simulation of nanostructures using COMSOL multiphysics
(Trans Tech Publications, 2014)
Currently, Computer simulation has become an essential part of nanotechnology and engineering and science. Digital analysis of components, in particular, is important when developing new products or optimizing designs. ...
COMSOL Multiphysics Simulation in biomedical engineering
(Trans Tech Publications, 2014)
In the past two decades, COMSOL Multiphysics Software Package have emerged as a powerful tool for simulation, particularly in Nanotechnology and most importantly in biomedical application and various application involving ...
Plant diseases detection using nanowire as biosensor transducer
(Trans Tech Publications, 2014)
The plant disease such as Cucumber Mosaic Virus (CMV) and Papaya Ring Spot Virus (PRSV) is a most dangerous disease that can decrease productivity and quality of the vegetable and fruit. Besides that, its also can destroy ...
Characterization of bio-oil from palm kernel shell pyrolysis
(Faculty of Mechanical Engineering, Universiti Malaysia Pahang, 2014-12-01)
Pyrolysis of palm kernel shell in a fixed-bed reactor was studied in this paper. The objectives were to investigate the effect of pyrolysis temperature and particle size on the products yield and to characterize the bio-oil ...
Mask design and fabrication of Micro/Nanowire biochip for reliable and repeatability pattern transfer
(Trans Tech Publications, 2014)
In Micro/Nanowire fabrication, the alignment and exposure process are the most critical steps in photolithography process, and indeed for the whole biochip processing. This process determines the success of transferring ...
Low cost detection of pH and its effect on the capacitive behavior of micro-gap sensor
(Trans Tech Publications, 2014)
The article describes the fabrication and characterization of silver microgap sensor on silicon substrate. By employing cheap photolithography process the proposed microgap sensor has been fabricated. The silver microgap ...
Effect of drill point angle on surface integrity when drilling titanium alloy
(Trans Tech Publications, 2014)
Surface integrity of machined component is of major importance for the reliability and safety requirements during in service especially for the aerospace applications. This paper presents an investigation on the effect of ...
Conventional photolithography and process optimization of pattern- size expansion technique for nanogap biosensor fabrication
(Trans Tech Publications, 2014)
For a submicron photolithography process, there is little room for error. In this paper, an optimized technique for photoresist (PR) development is reported, to fabricate a nanogap biosensor for application in biomedical ...
Fabrication of nanostructure based biosensor for biomolecules detection
(Trans Tech Publications, 2014)
Lately, nanostructure based biosensor application has drawn a lot attention among fellow researchers because of speciality to detecting cell, tissue and even disease caused by viruses either from humans, animals or ...