Search
Now showing items 41-50 of 63
Design and simulation of Piezoresistive pressure sensor
(Universiti Malaysia Perlis, 2008-03)
The piezoresistive effect describes the changing electrical resistance of a material
due to applied mechanical stress. Electrical resistor will change its resistance when it
experiences a strain and deformation. Pressure ...
Optimization of Nitride deposition process using Taguchi method
(Universiti Malaysia Perlis, 2008-04)
The process of plasma enhanced chemical vapor deposition silicon nitride film which is used as barrier layer for the doped oxide in premetal dielectric (PMD) application and optimized using Design of Experiment (DOE) ...
Analysis of square shaped Microstructure based Electron Beam induced deposition
(Universiti Malaysia Perlis, 2008-04)
The fabrication of square shaped microstructures is studied by electron beam
induced deposition (EBID) method using Scanning Electron Microscopy (SEM). EBID is
a technique that allows the resistless deposition directly ...
Fabrication and simulation of PNP Bipolar transistor based on Spin On Dopant technique and Electrical characterization
(Universiti Malaysia Perlis, 2008-04)
In this project, the fabrication and simulation of pnp transistor was performed.
From fabrication process, the electrical characteristic and sheet resistance of the device was observed by 4 point probe measurement. The ...
Optimization on oxidation process using 2K factorial design method
(Universiti Malaysia Perlis, 2008-04)
Silicon technologies progress in the last twenty years has traced the path to the
unprecedented revolution of information technologies, which has changed everybody’s
lifestyles. With the help of software, the world of ...
Design and analysis of low power using Sleepy Stack and Zig-Zag technique
(Universiti Malaysia Perlis, 2008-04)
Now days the design of CMOS becomes greater where the number of transistor in design increased largely. However there are some problem that occurs during the excellent
design and the increasing of transistor where the ...
Resonant Micromachined magnetic field sensor
(Universiti Malaysia Perlis, 2008-04)
This project is about the development of a micromachined magnetic field sensor. The operation of this sensor is based on a shift of the resonant frequency of a resonating
microstructure in presence of a magnetic field. ...
Design and analysis of Three-Axis Piezoresistive accelerometer
(Universiti Malaysia Perlis, 2008-04)
Recently, micro-electromechanical system (MEMS) technologies have been used to
manufacturer accelerometers. MEMS sensors include tranducers elements and the necessary signal conditioning electronics integrated together ...
Smart Arm Robot using Visual Basic program
(Universiti Malaysia Perlis, 2008-04)
The aim of the project was to design the software using Visual Basic program to control the robot arm, design the electronic circuit and build the Robot Arm. The
controlling of the robot arm using wireless radio frequency ...
Analysis of the deposited carbon during Electron Beam Induced Deposition (EBID) in Scanning Electron Microscope using Secondary Ion Mass Spectrometry (SIMS)
(Universiti Malaysia Perlis, 2008-03)
Many experiments on the mechanics of nanostructures require the creation of rigid
clamps at specific locations. In this work, electron beam induced deposition (EBID) has been used to deposit carbon films that are similar ...