Search
Now showing items 11-17 of 17
Using gibbs standard state free energy and a power regulating device to predict and control the fabrication of nanoporous alumina
(VBRI press, 2013-12)
The basic concept of Gibbs standard state free energy predicts a favorable condition for both room and high temperature fabrication of nanoporous alumina in phosphoric acid electrolyte. The anodization of aluminum foil in ...
Electrochemical measurement of PBS using cyclic voltammetry and AAO fabricated at ambient temperature and low potential
(Trans Tech Publications, 2013)
Anodic aluminium oxide fabricated at ambient temperature and low potential in phosphoric acid electrolyte was used as the working electrode for the electrochemical measurement of phosphate buffer saline under different pH ...
Electrochemical corrosion behaviour of Mg-(Ca,Mn) sacrificial anodes
(Trans Tech Publications, 2013)
The aim of the study is to identify the effect of Ca in Mg-Mn alloy on electrochemical corrosion behavior for the development of high performance sacrificial anode. Mg alloys were fabricated by casting technique under an ...
Corrosion behaviour of anodised powder metallurgy aluminium-magnesium composites
(Trans Tech Publications, 2013)
The corrosion behavior of anodized powder metallurgy Al/2wt%Mg composites reinforced with the short fibre alumina Saffil™ was studied using potentiodynamic polarization in 3. 5% NaCl solutions. The materials under investigation ...
Effect of temperature of oxalic acid on the fabrication of Porous anodic alumina from Al-Mn alloys
(Hindawi Publishing Corporation, 2013)
The influence of temperature of oxalic acid on the formation of well-ordered porous anodic alumina on Al-0.5 wt% Mn alloys was studied. Porous anodic alumina has been produced on Al-0.5 wt% Mn substrate by single-step ...
Effect of deposition time on properties of ZrO2 coating prepared using electrolytic method
(Trans Tech Publications, 2013)
AISI 440C martensitic stainless steel is one of the most widely studied engineering materials for its tribological properties. It is capable of attaining the best mechanical properties such as high strength and hardness ...
Electrical properties of chitosan-ferredoxin film
(American-Eurasian Network for Scientific Information (AENSI), 2013)
In this study, chitosan was blended with ferredoxin to further improve the electrical properties of sensing film. Chitosan powder was dissolved in 2% of acetic acidand blended with ferredoxin. The mixture was subsequently ...