Browsing Mohd Nazree Derman, Assoc. Prof. Dr. by Title

Now showing items 22-41 of 66

    • The effect of electrolyte temperature on formation of porous aluminium oxide films in anodising process 

      Juyana, A Wahab         ; Mohd Nazree, Derman, Dr.; Zuraidawani, Che Daud (AENSI Publisher All rights reserved, 2013-10)
      A porous aluminium oxide film formed on aluminium was prepared in a mixed electrolyte of phosphoric acid and acetic acid solution. The morphology, growth and thickness of the film were investigated. The anodising process ...

    • Effect of heat treatment on microstructure and corrosion behavior of Az91d magnesium alloy 

      Chye, Lih T.; Mohd. Zamzuri, Mohammad Zain; Siti Norbahiyah, Mohamad Badari; Khairul Azwan, Ismail, Dr.; Mohd Nazree, Derman, Dr.; Suhaimi, Illias (Trans Tech Publications, 2013)
      An AZ91D ingot in the as-cast condition was homogenized by heat treatment process. Then, the microstructures produced and corrosion behaviour after heat treatment was studied in detail. As-cast AZ91D was recrystallize by ...

    • The effect of heat treatment on the anode efficiency of Magnesium sacrificial anode 

      A.M.H., Firdaus; Saiful Rizam, Shamsudin; Shamsul Baharin, Jamaludin; Mohd Nazree, Derman (Universiti Malaysia Perlis, 2009-12-01)
      High efficiency sacrificial anode from Mg alloy is needed as it has higher capability of protecting underground metal structure against corrosion in cathodic protection. Solution treatment was applied to Mg sacrificial ...

    • The effect of heat treatment on the open circuit potential of magnesium sacrificial anode 

      A. M. H., Firdaus; Shaiful Rizam, Shamsudin; Shamsul Baharin, Jamaludin; M. N., Derman; Mohd Fitri, Mohd Wahid; M. Z., Ruhiyudin (University of Malaya, 2009)
      Magnesium sacrificial anode that possess high value of open circuit potential, Eoc is needed as it can protect larger area of underground metal structure in cathodic protection. Solution treatment was applied on magnesium ...

    • Effect of manganese content on the fabrication of porous anodic alumina 

      Voon, Chun Hong; Mohd Nazree, Derman, Dr.; Uda, Hashim, Prof. Dr. (Hindawi Publishing Corporation, 2012)
      The influence of manganese content on the formation of well-ordered porous anodic alumina was studied. Porous anodic alumina has been produced on aluminium substrate of different manganese content by single-step anodizing ...

    • Effect of sintering on the physical and mechanical properties of Co-Cr-Mo (F-75)/HAP composites 

      Nur Maizatul Shima, Adzali, Dr.; Shamsul Baharin, Jamaludin, Prof. Dr.; Mohd. Nazree, Derman, Dr. (Universiti Kebangsaan Malaysia, 2013-12)
      This paper reports on the effects of HAP addition and sintering temperature on the microstructure and properties of the F-75/HAP composites fabricated by powder metallurgy. Co-Cr-Mo (F-75) is used in orthopedics because ...

    • Effect of solution treatment on Mg galvanic anodes in CaSO4 – MG(OH)2 aqueous solution 

      A. M. H., Firdaus; Shaiful Rizam, Shamsudin; Shamsul Baharin, Jamaludin, Prof. Dr.; M. N., Derman; Mohd Fitri, Mohamad Wahid; C. I., Mahdi (PETRONAS, 2009-07-20)
      The effect of heat treatment on the Mg anode was investigated in CaSO4-Mg(OH)2 aqueous solution. The Mg sample was solutionised at 150oC, Pure and untreated Mg anode were also studied as a reference. Eoc and Tafel corrosion ...

    • Effect of temperature of oxalic acid on the fabrication of Porous anodic alumina from Al-Mn alloys 

      Mohd Nazree, Derman, Dr.; Foo, Kai Loong; Khairel Rafezi, Ahmad, Dr.; Uda, Hashim, Prof. Dr.; Voon, Chun Hong (Hindawi Publishing Corporation, 2013)
      The influence of temperature of oxalic acid on the formation of well-ordered porous anodic alumina on Al-0.5 wt% Mn alloys was studied. Porous anodic alumina has been produced on Al-0.5 wt% Mn substrate by single-step ...

    • The effects of autocatalyst copper coating of SiCp on the microstructure of CuSiCp composites 

      Azmi, Kamardin; Mohd Nazree, Derman; Shaiful Rizam Shamsudin; Mazlee, Mohd Noor; J.A.H., Iqwan (Universiti Malaysia Perlis, 2009-12-01)
      In this paper, the autocatalyst copper coating (ACC) of silicon carbide particle (SiCp) was performed after a sequence of surface treatment, sensitization and surface activation processes. The ACC process was operated ...

    • Effects of Magnesium addition on corrosion behaviour of Al-Mg composite fabricated using Powder Metallurgy method 

      Normah Cheman; Mohd Nazree Derman; Nur Maizatul Shima Adzali (Universiti Kebangsaan Malaysia (UKM), 2008-12-03)
      The study was focusing the effects of magnesium addition on corrosion behaviour of PM Al composite. The corrosion behaviour between PM Al composite reinforced with short fibres alumina Saffil™ with and without 2 wt% of ...

    • Electrical properties of chitosan-ferredoxin film 

      Shantini, Devi; Irwana, Nainggolan, Dr.; Mohd Nazree, Derman, Dr.; Tulus Ikhsan, Nasution (American-Eurasian Network for Scientific Information (AENSI), 2013)
      In this study, chitosan was blended with ferredoxin to further improve the electrical properties of sensing film. Chitosan powder was dissolved in 2% of acetic acidand blended with ferredoxin. The mixture was subsequently ...

    • Electrochemical behaviour of PM Al-Mg composites reinforced with alumina saffil short fibres 

      Normah, Cheman; Mohd Nazree, Derman; Ismail, Talib (Universiti Malaysia Perlis, 2009-12-01)
      The electrochemical behaviour of powder metallurgy (PM) Al-Mg composites, PM Al composites and PM Al-Mg alloy have been compared with standard PM Al in 3.5 wt% NaCl. The effects of alumina Saffil short fibres reinforcement ...

    • Electrochemical characterisation of hybrid activators for aluminium sacrificial anodes in natural sea water 

      Mohd Subhi, Din Yati; Mohd Nazree, Derman, Dr.; Mahdi, Che Isa; Mohd Moesli, Mohammad; Hasril, Nain (Malaysian Citation Centre & Ministry of Education, 2013)
      This paper reports on the electrochemical behaviour of as-cast Al-Zn-Mg alloys activated by tin (Sn) and ruthenium dioxide (RuO2) in natural sea water. The potential and advantages of Sn and RuO2 as hybrid activators in ...

    • Electrochemical corrosion behaviour of Mg-(Ca,Mn) sacrificial anodes 

      Shaiful Rizam, Shamsudin; Azmi, Rahmat, Assoc. Prof. Dr.; Mahdi, Che Isa; Mohd Nazree, Derman, Dr.; Abdul Razak, Daud (Trans Tech Publications, 2013)
      The aim of the study is to identify the effect of Ca in Mg-Mn alloy on electrochemical corrosion behavior for the development of high performance sacrificial anode. Mg alloys were fabricated by casting technique under an ...

    • Electrochemical measurement of PBS using cyclic voltammetry and AAO fabricated at ambient temperature and low potential 

      Alaba Oladeji, Araoyinbo; Mohd Nazree, Derman, Dr.; Azmi, Rahmat, Prof.; Khairel Rafezi, Ahmad, Dr. (Trans Tech Publications, 2013)
      Anodic aluminium oxide fabricated at ambient temperature and low potential in phosphoric acid electrolyte was used as the working electrode for the electrochemical measurement of phosphate buffer saline under different pH ...

    • The electromechanical study on Magnesium sacrificial anode in cathodic protection 

      Mohd Nazree Derman; Zulkifli Zainon; Shaiful Rizam Shamsudin (Universiti Kebangsaan Malaysia (UKM), 2008-12-03)
      Magnesium is among the anode material usually applied in cathodic protection in soil application. The corrosion behaviour of Mg anode was studied to understand corrosion behaviour of the Mg anode. The electrochemical ...

    • Erosion corrosion of PM Aluminium Reinforced with Alumina Saffil in NaCI and sand solution 

      Mohd Nazree, Derman; Mohd Faiz, Bahardin; Kamrosni, Abdul Razak; Noraziana, Parimin; Zaherudin, Kasmuin; Shamsul Baharin, Jamaludin (Universiti Teknologi Malaysia (UTM), 2007-11-26)
      The erosion-corrosion behaviour of anodised and non anodised PM aluminium matrix composite in sodium chloride (NaCl) containing sand has been studied. The AI composite reinforced with 15 wt % short fibre alumina Saffil ...

    • Fabrication of calcium phosphate coating on pure magnesium substrate via simple chemical conversion coating: surface properties and corrosion performance evaluations 

      Mohd Amin, Farhan Zaludin; Zul Azhar, Zahid Jamal; Mohd Nazree, Derman; Mohd Zaheruddin, Kasmuin (Elsevier, 2018)
      The main objective of the current work was to fabricate calcium phosphate (CaP) coating on 99.9% purity magnesium, Mg substrate through simple chemical conversion method and evaluated the surface properties and corrosion ...

    • Grafting amino-acid molecular imprinted polymer on carbon nanotube for sensing 

      N. Farhanah, Ab. Halim; Mohd Noor, Ahmad, Prof. Dr.; Ali Yeon, Md Shakaff, Prof. Dr.; Mohd Nazree, Derman, Dr. (Elsevier Ltd., 2013)
      Molecular imprinted polymer (MIP) is a good matrix that exhibit satisfactory recognition ability when integrated onto sensing transducer. We report on the preparation of such material by graft-polymerizing MIP on the surface ...

    • Grafting amino-acid molecular imprinted polymer on carbon nanotube for sensing 

      Ali Yeon, Md Shakaff, Prof. Dr.; Halim, N. F. A; Mohd Noor, Ahmad, Prof. Dr.; Nazree, Deraman, Dr. (Malaysian Technical Universities Network (MTUN), 2012-11-20)
      Molecular imprinted polymer (MIP) is a good matrix that exhibit satisfactory recognition ability when integrated onto sensing transducer. We report on the preparation of such material by graft-polymerizing MIP on the surface ...