Search
Now showing items 21-30 of 62
Wavelet based distortion measurement and enhancement of ECG signal
(Institute of Electrical and Electronics Engineers (IEEE), 2012-02-27)
This paper describes the research carried out to eliminate the noise found in ECG signal and cardiac rhythm using Coiflet wavelet since its scaling function is closely related to the shape of ECG and suited for denoising ...
Response of induction motor to balance voltage sags and momentary interruption
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper presents result of experimental study of induction motor behavior when subjected to voltage sags and interruption. Small induction motors were used to investigate this phenomenon. A shaffner “Profline 2100” EMC ...
Comparison of flux density between different thicknesses of non oriented electrical steel material using FEM software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Generally, 0.35mm has better performance than 0.5mm thickness of material in terms of losses reduction and money saving potential. This paper presents the comparison of the 0.35mm and 0.5mm thickness of non oriented ...
Harmonic performance of single phase transformer with DC biased
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Direct current (DC) flowing through the earthed
neutrals of transformer windings causes a DC
component in magnetizing current. Owing to nonlinearity,
the waveform of this current is strongly
distorted. A high enough ...
Investigation of influence of voltage source type on harmonic characteristics
(Institute of Electrical and Electronics Engineers (IEEE), 2010-06-23)
This paper discussed about influence of voltage source types on harmonic characteristics. Usually, the voltage source is sinusoidal. But in actually, the condition of the load is has voltage sources through the elements ...
Testing of contactors under voltage sag and non-sinusoidal voltage conditions
(Institute of Electrical and Electronics Engineers (IEEE), 2010-11-29)
Sensitivity of electromagnetic contactors for voltage sags and non-sinusoidal voltage supply has been carried out by laboratory testing. Effects of sag characteristics such as; sag magnitude, sag duration and point on wave ...
The impacts of stator outside diameters on induction motor nameplates: Analysis by using a finite element
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)
Design stimulation by software is important in order to save money and time. This paper is using stimulation software, which is a finite element method, to analyze the stator outside diameter impact on rated current, horse ...
The impacts of stator materials on induction motor nameplate parameters for high performance
(Institute of Electrical and Electronics Engineers (IEEE), 2010-12-13)
Core materials and magnet wire sizes were analyzed in order to find out the impacts on nameplate for high performance motor. Stack length and back core iron depth of stator geometry design are the parameters involve in ...
Induction motor behavior due to unsymmetrical and symmetrical faults
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Voltage sags are generally caused by faults on transmission and/or distribution systems. The voltage produced may be either unsymmetrical or symmetrical, depend on type of faults. Unsymmetrical fault is faults caused by ...
Performance comparison different thickness of non oriented electrical steel material using analysis and performance chart from FEM software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
With market condition today, the economics are
such that users and engineer are looking for the best
fit for the application at the most reasonable cost in
purchasing induction motors. Generally, 0.35mm
thickness of ...