Search
Now showing items 11-20 of 62
Induction motor behavior due to symmetrical and un-symmetrical faults
(Universiti Malaysia Perlis (UniMAP), 2012-06-18)
This paper presents induction motor behavior caused by symmetrical and unsymmetrical
faults. PSCAD/EMTD power system simulation was used for a simple model and the investigation
purpose. Voltage sags are generally caused ...
Investigation of photovoltaic modules cooling system
(Universiti Malaysia Perlis (UniMAP), 2012-06-18)
It is well known that the power and efficiency of photovoltaic (PV) module usually falls at the rate of ~0.5%/°C and ~0.05%/°C respectively as increase of ambient temperature. The electrical efficiency of PV cell depends ...
Loss prediction of induction motor using OPERA 2D software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
The paper discusses the factors which determine the
losses of induction motor. The loss mechanisms are
described in this paper and it is related to the
performance and design characteristics of induction
motor such as ...
Epstein and iron loss test for Incoming Quality Assurance (IQA)
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Epstein test is well known method to test the specific total loss in magnetic material. Epstein test procedures are complicated as well as destructive test. Therefore, the Iron Loss Tester is an alternative test and can ...
Statistic data analysis of localized magnetic flux density and power loss
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
The experiment data were collected by using the search coil technique and temperature arise with time in order to measure the magnetic flux density and power loss. Statistic data analysis and engineering knowledge are tools ...
In-plane flux distribution in the mix 60o- 45o T-joint of three phase transformer core
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper describes the result of measurement of inplane
flux distribution on 100kVA 3phase distribution
transformer assembled with the mix 60o- 45o T-joint and
mitred lap corner joint with stagger yoke of 10mm. ...
Optimization of photovoltaic module electrical characteristics using genetic algorithm
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper presents the optimization of PV module
electrical characteristics using genetic algorithm (GA).
A mathematical modeling was used to characterize the
electrical characteristics of PV module. A 180 W, 30
V, ...
Simulation of flux distribution and loss calculation at three-phase transformer core with the mix 60o-45o T-joint
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper describes the result of simulation of flux
distribution on 100kVA 3phase distribution transformer
assembled with 23o T-joint and mitred lap corner joint with
stagger yoke and limb for one lamination. The ...
Copper rotor development process of induction motor
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper proposes the technique for developing a
copper rotor for AC induction motor. A simple
substitution of copper for aluminum in the rotor
conductor bars will generally provide a significant
reduction in I²R ...
Potential of solar energy harvesting in Ulu Pauh, Perlis, Malaysia using solar radiation - Analysis studies
(Elsevier B.V., 2012-12-27)
This paper presents analysis studies of solar energy harvesting potential in Ulu Pauh, Perlis, Malaysia which located at 6.462°N, 100.351°E. Solar radiation is radiant energy received from the sun, from both direct and ...