Search
Now showing items 21-28 of 28
Characteristics of Fe-yttria composites fabricated by powder metallurgy method
(Trans Tech Publications, 2013)
This study is focused on fabricating and characterizing iron (Fe) composites prepared by powder metallurgy route reinforced with varying weight of Yttria (Y2O3). Composites were prepared based on 5 wt. % to 15 wt. % of ...
Fabrication and characterisation of powder metallurgy Fe-Cr Matrix composites reinforced with Al2O3
(Trans Tech Publications, 2013)
Sintered powder metallurgy Fe based composites with advanced mechanical properties have been proposed as substitutes for more expensive cemented carbide and wrought alloys in many applications, especially as inexpensive ...
Dry sliding wear and compressive strength of Fe-Cr matrix composite with and without Al2O3 reinforcement
(IEEE Conference Publications, 2011)
Fe-Cr matrix composites reinforced with Al2O3 particulates fabricated by powder metallurgy (PM) method offer potential for cheaper wear resistance materials and high temperature application. The influence of Al2O3 amount ...
Physical properties of FG HAP-F75 fabricated by powder metallurgy
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Functional graded (FG) HAP-F75 was prepared by powder metallurgy technique. Three layers of functional graded HAP-F75 was fabricated using single punch hydraulic press. The fabrication technique consists of mixing, pressing ...
Solid state sintering of Co-Cr-Mo (F 75): Microstructure and properties
(SIRIM, 2010-11-22)
Corrosion behaviour of powder metallurgy aluminium matrix composite reinforced with alumina Saffil™ short fibre
(Universiti Malaysia Perlis, 2010-06-09)
The corrosion behaviour of PM Al composite will be affected by the presence of alloying element and reinforcing phase in the composite. This study focused on magnesium and alumina Saffil™ short fibres reinforcement affected ...
Mechanical properties of Sn-0.7Cu/Si 3N 4 lead-free composite solder
(Elsevier B.V., 2012-10)
The use of reinforcing high performance ceramic particulates in monolithic lead-free solder is one way to improve the service temperature and mechanical behavior of a solder joint. In this study, various compositions of ...
Intermetallic compound formation on solder alloy/cu-substrate interface using lead-free sn-0.7cu/recycled-aluminum composite solder
(Scientific.Net, 2012-12)
Feasibility of using recycled-Aluminum (re-Al) as reinforcement particulates in Sn-0.7Cu is assessed by powder technology method, whereby re-Al particulates are produced from discarded aluminum beverage cans. This paper ...