Browsing School of Manufacturing Engineering (FYP) by Subject "Injection moulding"
Now showing items 1-7 of 7
-
Analysis of shrinkage on the thick plate part using Response Surface Methodology (RSM)
(Universiti Malaysia Perlis (UniMAP), 2016-06)This study is about research on the analysis of the quality (shrinkage) on the thick plate part using response surface methodology (RSM). The objective of this study is to improve the quality of thick plate part by ... -
Analysis of shrinkage on thick plate part using genetic algorithm
(Universiti Malaysia Perlis (UniMAP), 2016-05)Injection moulding process has been widely used to produce plastic products with various shapes for high productivity and high volume products with low cost. However there are several defect which can influence the quality ... -
Analysis of strength on thick plate part using Taguchi Method
(Universiti Malaysia Perlis (UniMAP), 2016-06)The tensile strength of the certain moulded parts is important, especially for the product which requires the strength for functionality and quality. It is known that parameter setting of injection moulding had interaction ... -
Analysis of Warpage on front panel housing using Response Surface Methodology
(Universiti Malaysia Perlis (UniMAP), 2016-06)In injection moulding process, moulded plastic parts is consider one of the most economical manufacturing process with high volume of plastic parts produces. Causes of variations in injection moulding are related to the ... -
Shrinkage and warpage on front panel housing using Genetic Algorithm (GA)
(Universiti Malaysia Perlis (UniMAP), 2016-06)In materials processing, quality and productivity are most important and must be controlled for each product type produced. In an injection moulding process, quality is measured in term of warpage of moulded parts while ... -
Stabilization of production rate for plastic products (Single CD) by using injection moulding machine
(Universiti Malaysia PerlisSchool of Manufacturing Engineering, 2008-04)A researched project was designed in order to study the stabilization of production rate for plastic product (single CD) by using injection moulding machine. The study was carried out by identifying the operating parameters ... -
To study a design of two and three-plate mould for injection moulding process
(Universiti Malaysia PerlisSchool of Manufacturing Engineering, 2008-04)The purpose of this project to learn and practice design guideline for plastic injection moulding process in design mould. There include to understand all the factor that will affect the design product example poor design ...