Search
Now showing items 11-20 of 156
Decolorization of azo dye by ozonation
(Universiti Malaysia Perlis (UniMAP), 2010-02)
Decolourization and Chemical Oxygen Demand (COD) removal of azo dye solution in
different ozonation time and biodegradation processes were evaluated to apply for
wastewater treatment containing azo dye. Reactive Red 120, ...
Changeover time reduction for die cut machine
(Universiti Malaysia Perlis (UniMAP), 2010)
A rapid changeover capability is widely acknowledged as an essential prerequisite to
flexible, responsive small batch manufacturing. Its importance in mass customization is
recognized, where minimal losses need to be ...
Design, fabrication and analysis of a uniform distribution tempeture cooking chamber
(Universiti Malaysia Perlis (UniMAP), 2010)
Adsorption of copper solution on chitosan beads adsorbent
(Universiti Malaysia Perlis (UniMAP), 2010-04)
The use of waste as an adsorbent for removal of copper from aqueous solution was investigated due to its low cost value. Chitosan which was derived from crustacean shells was used in this study. The adsorption experiment ...
Concrete sludge and paper sludge (CSPS) brick
(Universiti Malaysia Perlis (UniMAP), 2010-04)
Paper sludge is a waste from pulp and paper industry while concrete sludge is a waste
from construction industry, has caused environmental impact problem besides the
increasing of disposal cost. Focus this study, to ...
Manufacturing process of rotary valve for motorcycle engine
(Universiti Malaysia Perlis, 2010)
This project in its present form is the result of studies for manufacturing process of rotary
valve for motorcycle engine. The initial idea was to develop new technological process of
manufacturing of rotary valve. ...
Low cost ergonomics improvement in small & medium enterprise (SME)
(Universiti Malaysia Perlis (UniMAP), 2010)
Ergonomics is important in our daily lives, but not many of attention on it. We cannot run from problems in the ergonomics in undergoing daily activities. We are not aware that we are sitting on a chair that is too low, ...
Design and analysis mould for plastic injection moulding
(Universiti Malaysia Perlis (UniMAP), 2010)
In Malaysian, the plastic part is very popular product used in our life everyday. Most of plastic parts/products produced by injection process with the lost cost involved. The plastic injection moulding process category ...
Performance evaluation of a lemang oven
(Universiti Malaysia Perlis (UniMAP), 2010-03)
The way of processing lemang nowadays more modernized and sophisticated. Through understanding the physical and mechanical properties of material with heat transfer theory using Fourier’s Law and Newton’s Law of cooling ...
Design and development of milk powder dispenser
(Universiti Malaysia Perlis (UniMAP), 2010-04)
The trend of selling milk powder in aluminium packaging becomes a trend nowadays due to decrease the company cost. Therefore, the consumers have to buy an extra container or dispenser to keep the milk powder after opening ...