Now showing items 1-5 of 5

    • The effect of inoculation on properties of modified ductile Ni-resist alloy 

      Mohd Rashidi, Maarof; Mohd Hasbullah, Idris; Shayfull Zamree, Abd Rahim (Trans Tech Publications, 2014)
      In this study, ductile Ni-resist alloy with a minimum 18 wt. % nickel composition was modified. Up to 12 wt. % manganese was added together with 10 wt. % nickel before undergoing the inoculation process at various percentages ...
    • Improving warpage on thin shallow parts in two-plate moulds with conformal cooling channels 

      Shayfull Zamree, Abd. Rahim; Muhammad Syahril, Bahari; Siti Aishah, Adam; Mohd. Nasir, Mat Saad; Nooraizedfiza, Zainon (Praise Worthy Prize S.r.l., 2013-03)
      Nowadays, the trend of consumer products designed is getting smaller and most of cover is made from plastic which was produced by using injection molding process. Thus, the demand of thin shallow plastic parts in global ...
    • Milled groove square shape conformal cooling channels in injection molding process 

      Shayfull Zamree, Abd. Rahim; Safian bin Sharif, Prof. Dr.; Azlan, Mohd Zain, Dr.; Rozaimi, Mohd. Saad; Ahmad Fairuz, Mansor (Taylor and Francis Group, LLC., 2013-08)
      In designing molds for injection molding process, it is very difficult to achieve efficient cooling with uniform thermal distribution. To overcome these issues, the uses of conformal cooling channels with the uniform ...
    • Potential of conformal cooling channels in rapid heat cycle molding: a review 

      Shayfull Zamree, Abd Rahim; Safian, Sharif; Azlan, Mohd Zain; Rozaimi, Mohd Saad; Mohd Fathullah, Ghazli@ Ghazali (Wiley Periodicals, Inc., 2014)
      Rapid heat cycle molding (RHCM) can eliminate the weld line, increase flow length, and improve surface quality of the molded parts. However, the cycle time is much longer as compared to the conventional injection-molding ...
    • Strength of the weld line and warpage defects on the molded parts in injection molding process 

      S. M., Nasir; Khairul Azwan, Ismail, Dr.; Shayfull Zamree, Abd Rahim; Norshah Afizi, Shuaib (Praise Worthy Prize S.r.l., 2013)
      Strength at weld the line location and warpage problem in injection molding plastic component were not new problems in injection molding industries. Many researchers had emerged with several improvement techniques to reduce ...