Browsing School of Materials Engineering (Articles) by Author "shayfull@unimap.edu.my"
Now showing items 1-6 of 6
-
Comparison between single and multi gates for minimization of warpage using taguchi method in injection molding process for ABS material
Mohd. Nasir, Mat Saad; Khairul Azwan, Ismail; Shayfull Zamree, Abd Rahim; Norshah Afizi, Shuaib (Trans Tech Publications, 2013-12)In this study, a mold is designed in single and dual type of gate in order to investigate the deflection of warpage for thick component in injection molding process. Autodesk Moldflow Insight software was used as a medium ... -
Improving warpage on thin shallow parts in two-plate moulds with conformal cooling channels
Shayfull Zamree, Abd. Rahim; Muhammad Syahril, Bahari; Siti Aishah, Adam; Mohd. Nasir, Mat Saad; Nooraizedfiza, Zainon (Praise Worthy Prize S.r.l., 2013-03)Nowadays, the trend of consumer products designed is getting smaller and most of cover is made from plastic which was produced by using injection molding process. Thus, the demand of thin shallow plastic parts in global ... -
Milled groove square shape conformal cooling channels in injection molding process
Shayfull Zamree, Abd. Rahim; Safian bin Sharif, Prof. Dr.; Azlan, Mohd Zain, Dr.; Rozaimi, Mohd. Saad; Ahmad Fairuz, Mansor (Taylor and Francis Group, LLC., 2013-08)In designing molds for injection molding process, it is very difficult to achieve efficient cooling with uniform thermal distribution. To overcome these issues, the uses of conformal cooling channels with the uniform ... -
Potential of conformal cooling channels in rapid heat cycle molding: a review
Shayfull Zamree, Abd Rahim; Safian, Sharif; Azlan, Mohd Zain; Rozaimi, Mohd Saad; Mohd Fathullah, Ghazli@ Ghazali (Wiley Periodicals, Inc., 2014)Rapid heat cycle molding (RHCM) can eliminate the weld line, increase flow length, and improve surface quality of the molded parts. However, the cycle time is much longer as compared to the conventional injection-molding ... -
Strength of the weld line and warpage defects on the molded parts in injection molding process
S. M., Nasir; Khairul Azwan, Ismail, Dr.; Shayfull Zamree, Abd Rahim; Norshah Afizi, Shuaib (Praise Worthy Prize S.r.l., 2013)Strength at weld the line location and warpage problem in injection molding plastic component were not new problems in injection molding industries. Many researchers had emerged with several improvement techniques to reduce ... -
Warpage analysis with straight drilled and conformal cooling channels on front panel housing by using taguchi method
Shayfull Zamree, Abd Rahim; Safian, Sharif, Prof. Dr.; Azlan, Mohd Zain, Dr.; Rozaimi, Mohd Saad; Ahmad Fairuz, Mansor (Trans Tech Publications, 2014)The challenging in injection molding process is to get the uniform thermal distribution on the molded parts during the cooling stage which is mainly depend on the design of the cooling channels in injection mold. Poor ...