Search
Now showing items 2161-2170 of 2252
Kaolin Geopolymer as precursor to ceramic formation
(EDP Sciences, 2016)
This paper introduced the potential application of kaolin geopolymer as ceramic precursor. This is one of the alternatives to produce high strength ceramic at a slightly lower temperature. Upon sintering the conversion of ...
Increasing ABB FlexPicker Robot’s Degree of Freedom (DOF) using Flexible End Effector
(EDP Sciences, 2016)
The commissioning of a high speed parallel robot such as the ABB Flexpicker Robot into the industrial environment provides greater flexibility in picking, packaging or palletizing tasks. However, current configuration of ...
Manufacturing of fire resistance geopolymer: a review
(EDP Sciences, 2016)
Protection against fire using inorganic polymer is a new application of engineering technology. Even though, there are varieties of fire-protection materials, there is always a need for the development of new materials ...
Effect on Mechanical Properties of Heat Treated High Manganese Austenitic Cast Iron
(EDP Sciences, 2016)
This work presents an attempt to study the effect of manganese addition and heat treatment on higher carbon austenitic cast iron to form high manganese austenitic cast iron with reduced nickel content (Mn-Ni-resist) on ...
Highly response and sensitivity Chitosan-Polyvinyl alcohol based Hexanal sensors
(EDP Sciences, 2016)
This work is to study the sensing properties of chitosanpolyvinyl alcohol film sensors upon hexanal gas exposure using vapour sensing technique. The sensor fabrication process was done using electrochemical deposition ...
Correlation of the Na2SiO3 to NaOH Ratios and Solid to Liquid Ratios to the Kedah’s Soil Strength
(EDP Sciences, 2016)
Geopolymer was used for the soil stabilization of Kedah’s soil at different ratios of solid to liquid and Na2SiO3 to NaOH in order to achieve the desired compressive strength. The geopolymerization process which produces ...
Analysis of Strength on Thick Plate Part using Genetic Algorithm Optimisation Method
(EDP Sciences, 2016)
This study focuses on the optimisation of the injection moulding parameters to maximise the strength ofmoulded parts using a simulation software. The moulded parts were injected with Acrylonitrile- Butadiene-Styrene (ABS) ...
Influence of Sintering Temperature on Crystallization Behavior of Cordierite synthesized from Non-Stoichiometric Formulation
(EDP Sciences, 2016)
Cordierite body with formulation of non-stoichiometric composition (2.5 MgO. 1.8 Al2O3. 5 SiO2) was synthesized using conventional techniques with standard raw materials. The sintering and crystallization behavior of the ...
The effect of ZnO addition on the phase transformation, microstructure, and ionic conductivity of 8YSZ ceramics
(EDP Sciences, 2016)
In this paper the effect of zinc oxide (ZnO) addition on the phase transformation and ionic conductivity of 8 mol % Yttria-stabilised Zirconia (8YSZ) is investigated. Pure 8YSZ and ZnO doped YSZ ceramics are prepared using ...
An investigation of TiO2 addition on microstructure evolution of Sn-Cu-Ni solder paste composite
(EDP Sciences, 2016)
In this research, varying fraction of titanium oxide (TiO2) reinforcement particles was successfully incorporated into Sn-Cu-Ni solder paste in an effort to study the influence of TiO2 addition on microstructure evolution ...