Browsing School of Materials Engineering (FYP) by Subject "Aluminium"
Now showing items 1-7 of 7
-
The effect of temperature on the nitriding of Aluminium
(Universiti Malaysia Perlis (UniMAP), 2017-06)In this thesis writing, aluminium undergoes nitriding at three different temperatures which is 600°C, 625°C and 650°C. The surface also have been grind and polish with 800, 320 grinder paper and the other variable is rough ... -
The effect of various WT% of polypropylene on the hardness and anti-friction behavior of Al-filled polypropylene
(Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-05)This project is the study of hardness and anti-friction behavior of Al-filled polypropylene. Sample preparation involves sand casting and double screw extrusion to get finer size of polypropylene. The castings were done ... -
Effects of T6 treatment on the microstructural changes, hardness and thermal analysis of As-Cast Al-Si-Mg alloys
(Universiti Malaysia PerlisSchool of Materials Engineering, 2008-05)Aluminium-silicon-magnesium is usually applied in automotive industry such as in block engine. The main objective of this project is to study the changes in microstructure, hardness and the thermal analysis curve after ... -
Electroplating copper on aluminium alloy
(Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-06)Electroplating of copper on aluminium alloy surface by using copper sulphate solution as an electrolyte solution. This study was done to analyse the influence of voltage (5V-25V) on electroplating of copper on aluminium ... -
Fabrication of Al-based metallic glasses by mechanical alloying and hot consolidation
(Universiti Malaysia Perlis (UniMAP), 2017-04)This project is related to fabrication of aluminium based amorphous metallic glasses. Elemental powder of aluminium, copper and nickel were used for the purposed mentioned. The element powders with nominal composition ... -
Influence of H2C204 solution on formation of Porous AAO thin film
(Universiti Malaysia PerlisSchool of Material Engineering, 2008-04)The anodizing of aluminium has been investigated with the aim to realize nano-porous structures and nano-porous oxides for use as nano-templates. Before undergoing electrochemical oxidation, aluminium samples were cleaned ... -
Titled optimisation of anodising parameter with oxalic acid for the formation of anodic aluminium oxide
(Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-06)This thesis discussed on the optimisation of anodizing parameter with oxalic acid for the formation of anodic aluminium oxide (AAO) by using Taguchi Methods. During one-step of anodization technique is performed, porous ...