Browsing School of Materials Engineering (FYP) by Subject "Alloy"

Now showing items 1-5 of 5

    • Anodizing process of Mg alloy using low potential 

      Siti Auni Shafiqah, Makhtar (Universiti Malaysia Perlis (UniMAP), 2017-04)
      This project is focusing on the effect of anodizing on the coating Mg alloys. The Mg alloy was cut with constant length and width. The AZ80 is the type of Mg alloy used. It has high strength but also have high corrosion ...

    • The effect of iron addition and tungsten content on the corrosion resistance of w-pre alloy brass composite 

      Rozi, Ewol (University Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-05)
      In this project, the W-pre alloy brass composite is prepared through compacting method of powder metallurgy. Different composition of brass and tungsten was prepared and samples with iron addition sintered together using ...

    • Effect of solution treatment temperature on the microstructure of Fe-40Ni-24Cr alloy 

      Nuraliah Nazirah, Mohd Hassan (Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-06)
      The research study describes the effect of solution treatment temperature on the microstructure of Fe-40Ni-24Cr alloy. The working process is divided into three (3) working phases which are solution treatment process, ...

    • Influence of grain size on isothermal oxidation of Fe-33Ni-19Cr alloy 

      Izzat, Mohd Noor (Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-05)
      This research study describes the influence of grain size on isothermal oxidation of Fe- 33Ni-19Cr alloy. The Fe-33Ni-19Cr alloy plate was cut into desired dimension and undergone heat treatment of 3 different temperatures ...

    • Preparations of effect of heat treatment on the isothermal oxidation of Fe-33Ni-19Cr 

      Siti Aisyah, Che Sakdun (Universiti Malaysia Perlis (UniMAP), 2017)
      The effect of heat treatment on the isothermal oxidation of Fe-33Ni-19Cr alloy were investigated at temperature 850°C for 150 hours. The samples of Fe-33Ni-19Cr was given in a square plate shape was undergone heat treatment ...