Search
Now showing items 281-290 of 330
Effects of T6 treatment on the microstructural changes, hardness and thermal analysis of As-Cast Al-Si-Mg alloys
(Universiti Malaysia Perlis, 2008-05)
Aluminium-silicon-magnesium is usually applied in automotive industry such as in
block engine. The main objective of this project is to study the changes in microstructure, hardness and the thermal analysis curve after ...
Effect of different treatment of sugarcane fiber on mechanical properties, morphology and swelling behavior of Low density Polyethylene (LDPE) composites
(Universiti Malaysia Perlis, 2008-04)
The sugarcane bagasse is a residue widely generated in high proportions in the agroindustry. In this research, the bagasse fiber has been used as reinforcing component for polyethylene. The chemical treatments using sodium ...
Influence of chemical treatment on surface morphology of natural fiber
(Universiti Malaysia Perlis, 2008-04)
The interest in using natural fibers in composites has increased in recent years due
their lightweight, non-abrasive, combustible, non-toxic, low cost and biodegradable properties. However, lack of good interfacial adhesion, ...
The study of ultrasonic wave propagation in welded austenitic stainless steel
(Universiti Malaysia Perlis, 2008-04)
The propagation of ultrasonic waves in welded austenitic stainless steel (304 SS)
is examined. Significant variations of welded samples have been observed for different wave propagation directions. The welded samples for ...
Basic study on oxidation treatment of rice husk
(Universiti Malaysia Perlis, 2008-04)
White husk ash suitable for use as reinforcement material for metal matrix composites. This rice husk based reinforcement material are material are prepared by first removing volatile constituent by heating the husks to a ...
Robotic arm control using voice signal
(Universiti Malaysia Perlis, 2008-04)
A voice-based system has been developed to control a robot arm using oral commands. The system is divided into two main components: speech recognition engine and robotic control unit. In the speech recognition engine, a ...
A controller to perform a visually tracking task in laboratory environment
(Universiti Malaysia Perlis, 2008-04)
This project is to develop the software for controller to perform a visually guided tracking task in laboratory environment. The image processing include image conversion,
applying filter to remove noise, edge detection, ...
Dynamic vulcanization of waste paper filled of low density polyethylene (LDPE)/ ethylene propylene diene terpolymer (EPDM) composites
(Universiti Malaysia Perlis, 2008-04)
The effect of filler loading and dynamic vulcanization of paper sludge (PS) filled
LDPE/EPDM was investigated. Blends with different filler loading ranging from 0 to 60 wt % were prepared in Z-blade mixer at 180 °C and a ...
Influences of Phosphoric acid (H3PO4) solution on formation of Porous Anodic Aluminum Oxide (AAO) thin film
(Universiti Malaysia Perlis, 2008-04)
The main objective of this study is to analyze the effect of anodizing parameter focusing on anodizing voltage and phosphoric acid (H3PO4) concentration on the formation of porous anodic aluminum oxide (AAO) film. The ...
Study on properties of sugarcane bagasse fiber filled Polypropylene composites
(Universiti Malaysia Perlis, 2008-05)
Bagasse fiber is a residue of a sugarcane milling process. In this research, bagasse fiber has been used as filler in polypropylene (PP) resin to open up further
possibilities in waste management. The chemical treatment ...