Browsing by Title
Now showing items 21660-21679 of 79098
-
Fabrication of amorphous silicon microgap structure for energy saving devices
(Sains Malaysiana., 2012-06)We report here the fabrication of microgaps electrodes on amorphous silicon using low cost techniques such as vacuum deposition and conventional lithography. Amorphous silicon is a low cost material and has desirable ... -
The fabrication of artificial marble from dolomite (Batu Reput)
(The Mineral, Metals & Materials Society (TMS), 2006-01)Perlis is one of the major producers of "Batu Reput" in Malaysia and majority of the deposits contain of high-purity calcium and magnesium carbonate. The composition of Batu Reput is similar with the ordinary dolomite. ... -
Fabrication of BaTiO3 thin films through ink-jet printing of TiO2 sol and soluble Ba salts
(Elsevier Ltd., 2007)BaTiO3 thin films were prepared by ink-jet printing aqueous solutions of TiO2 sol and soluble Ba salts. Higher pH values (pH > 13) as well as higher than stoichiometric Ba (Ba:Ti = 1.1:1) salt additions were required to ... -
Fabrication of calcium phosphate coating on pure magnesium substrate via simple chemical conversion coating: surface properties and corrosion performance evaluations
(Elsevier, 2018)The main objective of the current work was to fabricate calcium phosphate (CaP) coating on 99.9% purity magnesium, Mg substrate through simple chemical conversion method and evaluated the surface properties and corrosion ... -
Fabrication of carbon nanotube field-effect transistor using shadow mask technique
(Universiti Malaysia Perlis (UniMAP), 2022-07)In this work, a new approach based on shadow mask has been reported for fabricating low-cost carbon nanotube field-effect transistor (CNFET) with interdigitated source and drain electrodes. The drop cast method is used for ... -
Fabrication of cobalt ferrite nanoparticles with a facile approach: Variations in structural, dielectric and morphological properties by influence of annealing temperature
(Universiti Malaysia Perlis (UniMAP), 2022-01)Spinel ferrites have a significant impact due to its physical and chemical properties. The sol-gel route has been employed in the present work, for achieving single phase nano-crystalline cobalt ferrites. All these samples ... -
Fabrication of functionally graded materials from Hydroxyapatite and F75 Cobalt alloy
(Universiti Malaysia PerlisSchool of Materials Engineering & School of Environmental Engineering, 2010-06-09)Functionally graded materials were fabricated using Hydroxyapatite (HAP) and F75 cobalt alloy. Both of these two materials are important in creating biomaterials that is compatible to the human tissue and at the ... -
Fabrication of graded Porous Hydroxyapatite by using coconut fibre
(Universiti Malaysia PerlisSchool of Materials Engineering, 2008-04)This study was carried out to develop sample hydorxyapatite (HA) cylindrical with have porous in particular part for example his external layers has solid part while on the inside it exist porous. Further it can make as ... -
The fabrication of heparin imprinted fiber membrane using electrospinning
(Universiti Malaysia Perlis (UniMAP), 2016-06)The studies of the fabrication of Heparin Imprinted Fiber membrane using Electrospinning was presented and investigated. This studies is about electrospinning method use to produce membrane from Polyvinylidene fluoride ... -
A fabrication of intelligent spiral reconfigurable beam forming antenna for 2.35 2.39GHz applications and path loss measurements
(EMW Publishing, 2013)A reconfigurable beam forming antenna prototype using a spiral feed line is proposed in this paper. The presented antenna is integrated with PIN diode switches at a specific location of spiral feed line. It is discovered ... -
Fabrication of ISFET for pH detection
(Universiti Malaysia Perlis (UniMAP), 2012-06-18)The ability to detect variation of pH from the changes ions concentration has gained Ion Sensitive Field Effect Transistor (ISFET) huge interest in various fields such as environmental monitoring in agricultural sector and ... -
Fabrication of Magnesium-Hydroxyapatite composites targeted for biodegradable implant application
(Universiti Malaysia Perlis (UniMAP), 2016-06)In the present study, as a lightweight metal with mechanical properties similar to natural bone, magnesium is gaining wide popularity as biodegradable materials targeted for temporary implant applications. The objective ... -
Fabrication of MEMS piezoresistive accelerometer for human gait analysis using laser micromachining
Gait analysis measurement is a method to access and identify gait events and the measurements of motion parameters involving the lower part of body. This significant method is widely used in rehabilitation, sports, as ... -
Fabrication of nanostructure based biosensor for biomolecules detection
(Trans Tech Publications, 2014)Lately, nanostructure based biosensor application has drawn a lot attention among fellow researchers because of speciality to detecting cell, tissue and even disease caused by viruses either from humans, animals or ... -
Fabrication of nanostructured anodized aluminum oxide (AAO) on Si-Al substrate for electronic applications
(Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2012)The growth of anodized aluminum oxide (AAO) film in anodizing process has been studied. The anodizing process was done in oxalic acid. The purpose of choosing oxalic acid as the electrolyte is to create AAO with a medium ... -
Fabrication of nanowire using ash trimming technique
(Trans Tech Publications, 2013)The paper present a report on fabrication of Nanowire using plasma oxidation, we monitor changes by studying the morphology and Δw/Δh, the study also revealed that the proposed fabrication method could potentially be used ... -
Fabrication of Photoanode and its performance in Photocatalytic fuel cell
(Universiti Malaysia Perlis (UniMAP)School of Materials Engineering, 2016-05)Photocatalytic fuel cell system (PFC) is a new technology for simultaneous organic wastewater treatment and electricity generation. Different composition of photoanode and different layers of photoanode were fabricated ... -
Fabrication of polysilicon nanowires using trimming technique
(AENSI Publications, 2012-04)Recently most researches are more to scaling down the electronic devices and this fact including component, structure and complexity of electronic devices. These matters also include fabrication of nanowires in certain ... -
Fabrication of polysilicon nanowires using trimming technique
(AENSI Publications, 2012-04)Recently most researches are more to scaling down the electronic devices and this fact including component, structure and complexity of electronic devices. These matters also include fabrication of nanowires in certain ... -
The fabrication of porcelain ceramic via Wet casting technique
(Universiti Malaysia PerlisSchool of Materials Engineering, 2008-04)Porcelain ceramic which composed of ball clay, kaolin, silica and feldspar were fabricated and investigated to study the effect of sintering temperature on mechanical properties. Two types of parameter were used in these ...