Browsing Azremi Abdullah Al Hadi, Assoc. Prof. Ts. Dr. by Issue Date
Now showing items 1-20 of 44
-
A comparative study of small antenna efficiency measurements
(Institute of Electrical and Electronics Engineering (IEEE), 2005)Three methods of determining an antenna's efficiency are compared to measure the efficiency of three different antennas (two monopole antennas with attenuator and surface mount resistor, and modified folded monopole patch ... -
The potentials of OCDM technique for local area network
(Institute of Electrical and Electronics Engineering (IEEE), 2006)Evolution of the optical fiber systems is currently seeing the general acceptance of wavelength division multiplexing (WDM) as the best mechanisms in increasing the transmission capacity of fiber optics. However, there are ... -
A MIMO LMS adaptive equalization approach in simulated radar emission
(Institute of Electrical and Electronics Engineering (IEEE), 2006)MIMO technology has attracted a lot of attention in the area of wireless communications such as radar applications, in term of increasing the spectral efficiency. This research paper will present the model of Simulated ... -
An investigation of Rayleigh distribution in reverberation chamber
(Institute of Electrical and Electronics Engineering (IEEE), 2006-09-12)Amplitude fluctuations in signals received over mobile radio channels are typically modeled by a Rayleigh distribution. The field statistics in the volume of the enclosure are shown to correspond to the Rayleigh statistics ... -
Performance comparison of serial and corporate feeding networks in a rectangular Microstrip patch antenna array
(Kolej Universiti Teknologi Tun Hussein Onn, 2006-12-19)One of the important aspects of a microstrip patch antenna array is the availability of the two feeding networks applicable to them, which are the serial and corporate feeding. A good impedance matching and optimal radiation ... -
Preliminary development of mini anechoic chamber
(Institute of Electrical and Electronics Engineering (IEEE), 2007)The purpose of mini anechoic chamber is to allow cost effective testing of microwave signal. It is because measurements of the radiation pattern are usually done in an anechoic chamber in order to avoid reflections from ... -
Performance analysis and prediction using circuit model in a microstrip patch array
(Institute of Electrical and Electronics Engineering (IEEE), 2007)This work is an effort in investigating and modeling an accurate Circuit Model derived from the Transmission Line Method (CM/TLM) by simulating a rectangular microstrip patch array using two different simulation techniques, ... -
Small rectangular parasitic plane as patch antenna ground plane for broadband WLAN application
(Institute of Electrical and Electronics Engineering (IEEE), 2007)This paper proposed a microstrip patch antenna for broadband WLAN application. The antenna is based on an octagonal patch, which is simulated and analyzed by using Microwave Office (MWO) for WLAN applications. The designed ... -
Comparison of Direct Contact Feeding methods for a Rectangular Microstrip Patch Antenna
(Universiti Malaysia Perlis, 2007)Microstrip patch antennas have a variety of feeding technique applicable to them. It can be categorized in accordance to the main power transfer mechanism from the feed line to the patch. Contactingfeeds investigated in ... -
A dual band planar monopole antenna with inverted-M parasitic plane
(Institute of Electrical and Electronics Engineering (IEEE), 2007)Introduction of parasitic plane as additional radiator helps to produce desired resonant frequencies, while helping to minimize the size of the antenna. A dual-band monopole antenna with parasitic plane is designed to ... -
Simplified Modeling, Simulation and Performance Analysis Using Circuit Model for a Corporate Feed Microstrip Patch Array
(Institute of Electrical and Electronics Engineers (IEEE), 2007-03-27)This work is an effort in investigating and modeling an accurate circuit model derived from the transmission line method (CM/TLM) by simulating a rectangular microstrip patch array using two different simulation techniques, ... -
Performance modeling and simulation of microstrip dipole array antenna for WLAN application
(Institute of Electrical and Electronics Engineering (IEEE), 2008)This paper proposed a performance simulation of a two-element, microstrip dipole array antenna for WLAN application. Simulation is done using two different simulation techniques, the circuit model (CM) derived from the ... -
Small rectangular parasitic plane with diamond patch antenna for WLAN application
(Institute of Electrical and Electronics Engineering (IEEE), 2008)The design and experimental demonstrations of a microstrip patch antenna for broadband WLAN application are presented. The physical parameters of the antenna, including based on a diamond patch, antenna input impedance, ... -
A parametric study of broadband planar inverted F antenna (PIFA) for WLAN application
(Institute of Electrical and Electronics Engineering (IEEE), 2008)A novel of comprehensive study and useful information for the design of broadband Planar Inverted F antenna (PIFA) is proposed. The antenna including the ground plane has a total dimension 6mm × 70mm × 30mm has been optimized ... -
Parametric performance simulation of a proximity-coupled fed microstrip dipole array
(Institute of Electrical and Electronics Engineering (IEEE), 2008-05-19)This work reports on the performance simulation of two element units of microstrip dipole array antennas for WLAN application. Simulation is done using two different simulation techniques, the circuit model (CM) derived ... -
A cylindrical Barium Strontium Titanate (BST) dielectric resonator antenna for 5.0 GHz wireless LAN application
(Institute of Electrical and Electronics Engineering (IEEE), 2008-05-19)This paper presents a dielectric resonator antenna (DRA) suitable for wireless communication applications at 5.0 GHz. The proposed DRA utilizes a ferroelectric material, Barium Strontium Titanate (BST) in cylindrical form ... -
Design of a microstrip patch antenna using low temperature co-fired ceramic technology
(Institute of Electrical and Electronics Engineering (IEEE), 2008-12-01)This paper presents the design of a single rectangular microstrip patch antenna for operation at 2.4 GHz frequency on Radio Frequency (RF) antenna application using Low Temperature Co-fired Ceramic (LTCC) technology. LTCC ... -
Design of split ring resonator filters for interference suppression in UWB
(Institute of Electrical and Electronics Engineering (IEEE), 2008-12-02)Microstrip stop-band filters based on complementary split ring resonators has been proposed in this project. Two shapes (circle and square) of SRRs have been investigated to come out device which is designed to suppress ... -
Development of a Lid Sealed furnace for the production of Magnesium alloys
(Universiti Kebangsaan Malaysia (UKM), 2008-12-03)An atmosphere-controlled furnace was designed for the casting process of highly reactive Mg metal and its alloys. Instead of open crucible furnace, the melting process was done under controlled atmosphere which contained ... -
Multiband fractal planar inverted F antenna (F-PIFA) for mobile phone application
(EMW Publishing, 2009)The design of a novel Fractal planar inverted F antenna (F-PIFA) based on the self affinity property is presented in this paper. The procedure for designing a Fractal Planar Inverted F Antenna is explained and three different ...