Search
Now showing items 11-20 of 25
Investigation on Nylon PA66 side arms using Taguchi and ANOVA analysis in reducing cost of producing urinary catheters
(Praise Worthy Prize, 2011-11)
This article discusses on a research experience and finding based on a collaboration with a medical equipment manufacturer in producing urinary catheters. The manufacturer had been spending high cost yearly to replace more ...
An approach to mechanization and automation of manual construction activity
(Praise Worthy Prize S.r.l., 2011-11)
Construction industry is very important to the developing country like Malaysia. Many challenges and difficulties must be faced by the developers of this particular field. Warszawski et. al [1] has reported that there are ...
Application of RSM to optimise moulding conditions for minimizing shrinkage in thermoplastic processing
(Trans Tech Publications Ltd, 2016)
This study focuses on the analysis of plastic injection moulding process simulation using Autodesk Moldflow Insight (AMI) software in order to minimize shrinkage by optimizing the process parameters. Two types of gates ...
Potential of conformal cooling channels in rapid heat cycle molding: a review
(Wiley Periodicals, Inc., 2014)
Rapid heat cycle molding (RHCM) can eliminate the weld line, increase flow length, and improve surface quality of the molded parts. However, the cycle time is much longer as compared to the conventional injection-molding ...
Improving the quality and productivity of molded parts with a new design of conformal cooling channels for the injection molding process
(John Wiley and Sons Inc., 2015)
In materials processing, quality and productivity are notably important and must be controlled for each product type produced. In the injection molding process, quality is measured as the extent of warpage of molded parts ...
Warpage Optimisation on the Moulded Part with Conformal Cooling Channels using Response Surface Methodology (RSM) and Glowworm Swarm Optimisation (GSO)
(EDP Sciences, 2017)
Today, there are many of optimisation method have been explored by previous researchers to find the appropriate processing parameters setting for the injection moulding process. From the previous researches, it has been ...
Warpage Optimisation on the Moulded Part using Response Surface Methodology (RSM) and Glowworm Swarm Optimisation (GSO)
(EDP Sciences, 2017)
Nowadays, there are various of optimisation methods that have been explored by many researchers to find the appropriate processing parameters setting for the injection moulding process. From the previous researches, it was ...
Investigation on Microstructure of Heat Treated High Manganese Austenitic Cast Iron
(EDP Sciences, 2016)
The effect of manganese addition and annealing heat treatment on microstructure of austenitic cast irons with high manganese content (Mn-Ni-resist) were investigated. The complex relationship between the development of the ...
The influence of Rice Husk Fiber on The Properties of Epoxidized Natural Rubber/Rice Husk Compounds
(EDP Sciences, 2016)
In this work, curing characteristics, tensile and physical properties of epoxidized natural rubber/ rice husk (ENR-50/RH)
compounds were investigated. Different RH loading (10, 20, 30, 40 and 50 Phr) and size (fine size ...
Optimisation of Shrinkage and Strength on Thick Plate Part Using Recycled LDPE Materials
(MDPI AG, 2021-04-05)
Achieving good quality of products from plastic injection moulding processes is very challenging, since the process comprises many affecting parameters. Common defects such as warpage are hard to avoid, and the defective ...