Search
Now showing items 21-30 of 43
Effect of heat treatment on microstructure and corrosion behavior of Az91d magnesium alloy
(Trans Tech Publications, 2013)
An AZ91D ingot in the as-cast condition was homogenized by heat treatment process. Then, the microstructures produced and corrosion behaviour after heat treatment was studied in detail. As-cast AZ91D was recrystallize by ...
Organic dye degradation with TiO2 catalyst/AAO template in the presence of H2O2
(Trans Tech Publications, 2013)
In this study, anodic aluminum oxide (AAO) fabricated from phosphoric acid electrolyte at ambient temperature was used as the porous template, while a sol gel procedure was used for the preparation of the TiO2 sol with the ...
Cu-SiCp composites as advanced electronic packaging materials
(Trans Tech Publications, 2014)
The demand for advanced thermal management materials such as silicon carbide particles reinforced copper matrix (Cu-SiCp) composites is increasing due to the stringent design requirement in the electronic packaging industries. ...
Characterization of PM Fe-Cr-Y₂O₃ composites prepared by microwave sintering technology
(Trans Tech Publications, 2014-01)
This research is focused on assessing the feasibility of the new and innovative microwave sintering technology for fabricating iron-chromium composites prepared via powder metallurgy route. Accordingly, the microwave ...
Characteristic and corrosion studies of rare earth (REE) based anodizing on AZ91D magnesium alloy
(Trans Tech Publications, 2014-01)
Oxide coatings on AZ91D magnesium alloy were prepared using anodizing technique with 10mA/cm2 current density for 5 minutes in electrolyte containing Mg (NO₃)₂ with NaVO₃ as an additive. The corrosion behaviors of different ...
Thermal expansion behavior of the electroless copper coated Cu-SiCp composites fabricated via the conventional powder metallurgical technique
(Trans Tech Publications, 2014-01)
The introduction of the metal matrix composites as the advanced electronic packaging materials is highly anticipated because their thermal properties can be engineered to match those of semiconductors, ceramics substrates ...
A study on the effect of modified electrolyte to the formation of AAO membrane in anodising process
(Trans Tech Publications, 2013)
The formation of anodic aluminium oxide (AAO) membrane in anodising process has been studied. The anodising process was done in two different type of electrolyte which are single phosphoric acid and a mixture of phosphoric ...
Using gibbs standard state free energy and a power regulating device to predict and control the fabrication of nanoporous alumina
(VBRI press, 2013-12)
The basic concept of Gibbs standard state free energy predicts a favorable condition for both room and high temperature fabrication of nanoporous alumina in phosphoric acid electrolyte. The anodization of aluminum foil in ...
A simple one-step anodising method for the synthesis of ordered porous anodic alumina
(Taylor & Francis, 2014)
Porous anodic alumina (PAA) has been produced on aluminium substrate by single-step anodising at 50 V in 0.3 M oxalic acid at 15°C for 60 min. The highly ordered pore and cell structure was achieved by subjecting the PAA ...
Electrochemical measurement of PBS using cyclic voltammetry and AAO fabricated at ambient temperature and low potential
(Trans Tech Publications, 2013)
Anodic aluminium oxide fabricated at ambient temperature and low potential in phosphoric acid electrolyte was used as the working electrode for the electrochemical measurement of phosphate buffer saline under different pH ...