Search
Now showing items 71-80 of 251
Sensor modeling for portable Electrical Capacitance Tomography system using simulation by COMSOL Multiphysics
(Innovative Computing, Information and Control (ICIC) International, 2012-10)
This work presents the development process for modeling a 16-segmented portable ECT (Electrical Capacitance Tomography) sensor (using FEM software package COMSOL Multiphysics). The physical sensors are 3D dimensional but ...
Design and analysis of magnetic flux leakage capsule
(International Frequency Sensor Association (IFSA), 2013-08)
Magnetic flux leakage (MFL) is among the current in-line non-invasive popular technique applied in pipeline condition control and monitoring. This paper discussed on the design and development of magnetic flux leakage ...
Investigation of conducting pins in sphere filled with phase change material for enhancing heat transfer in thermal energy storage
(Trans Tech Publications., 2012)
The utilisation of phase change material (PCM) for thermal energy storage (TES) can significantly enhance the energy savings achievable with renewable thermal systems. Sphere based packed bed systems have been used as TES ...
Stress analysis and failure characterizations of V-shaped epoxy adhesively bonded joint
(Trans Tech Publications, 2013)
This paper deals with stress and failure characteristics of V-shaped epoxy adhesive joint. Effect of scarf angle upon failure morphology was investigated by tensile test and monitoring using high speed camera. V-shaped ...
Design and development of a PC-based automated data logging system for measuring temperature
(Asian Research Publishing Network (ARPN), 2013-11)
Currently, accurate information of the temperature over time is required in medical, scientific, and various industrial applications. The objective of this work was to design and develop a fully automated microcontroller-based ...
Simplified equations for saturated steam properties for simulation purpose
(Elsevier B.V., 2013)
Steam is a very important fluid in industries and its thermodynamic properties have been tabulated. Graphs showing various relationships of steam thermodynamics have also been developed. However, the use of tables or graphs ...
Design of an intelligent diagnostic system for detection of knee injuries
(Trans Tech Publications, 2013)
Knee injuries is quite common in sport injuries and one of the most frequent happen are anterior cruciate ligament (ACL) knee injuries. There are two types of ACL injuries which are partial tear and complete tear. Currently ...
Effects of winding angles in biaxial ultimate elastic wall stress (UEWS) tests of glass gibre reinforced epoxy (GRE) composite pipes
(Trans Tech Publications, 2013)
This paper presents an experimental investigation into the influence of winding angles in multiaxial ultimate elastic wall stress (UEWS) tests of glass-fibre reinforced epoxy (GRE) composite pipes. Currently, UEWS test is ...
Evaluate the effects of various surface roughness on the tribological characteristics under dry and lubricated conditions for Al-Si alloy
(Scientific Research Publishing Inc. All rights reserved., 2012-07)
The effect of surface roughness average of hypereutectic aluminum silicon alloys (with 16 wt% Si) on the friction and wear was investigated. Various surface roughness average (Ra) of different degrees was verified as well ...
Analysis of finger movement by using motion information from glovemap and motion capture system
(IJENS Publishers, 2013)
Nowadays, through the advancement of science and technology, possibility of human finger provide information into computer is no longer question. Fingers movement and hand motion continuously being center of research in ...