In this paper, a new approach to improve power factor (PF) and reduced total harmonic distortion (THDi) is generated by a single phase induction motor is proposed. By designing the necessary technique and methodology, the ...

This paper describes the result of simulation of flux distribution on 100kVA 3phase distribution transformer assembled with 23o T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The ...

This paper describes the result of measurement of inplane flux distribution on 100kVA 3phase distribution transformer assembled with the mix 60o- 45o T-joint and mitred lap corner joint with stagger yoke of 10mm. ...

This paper presents the optimization of PV module electrical characteristics using genetic algorithm (GA). A mathematical modeling was used to characterize the electrical characteristics of PV module. A 180 W, 30 V, ...

This paper proposes the technique for developing a copper rotor for AC induction motor. A simple substitution of copper for aluminum in the rotor conductor bars will generally provide a significant reduction in I²R ...

Awareness towards green energy is on the hike and has been proven by many products being manufactured or pre-required to be assembled as energy saving devices mainly to save consumer from spending more on utility billing.

The power loss in laminated transformer cores is always greater than the nominal loss of the electrical steel laminations, by a factor known as the building factor. This paper discussed result of an investigation towards ...

Epstein test is well known method to test the specific total loss in magnetic material. Epstein test procedures are complicated as well as destructive test. Therefore, the Iron Loss Tester is an alternative test and can ...