Search
Now showing items 21-30 of 65
Synthesis, structural and electrical characterizations of SnO2 nanoparticles
(Universiti Malaysia Perlis, 2016)
Sol-gel synthesized SnO2 nanoparticles with an average size of 20.0 nm obtained at
100º C were gradually annealed to 800º C in air for 60 minutes. Crystal density, lattice
volume and microstrain are found to be nearly ...
Daily performance of kaneka g-sa060 amorphous silicon photovoltaic module based on solar irradiation and temperature in kangar malaysia as dc voltage source on spwm transformerless photovoltaic inverter
(Universiti Malaysia Perlis, 2016)
This paper presents the daily performance of Kaneka G-SA060 amorphous silicon
photovoltaic (PV) module. It is very important to study the data of solar
irradiation and temperature related to the performance of PV module. ...
Effect of temperature on sea water surface increment in North Sumatera Indonesia
(Universiti Malaysia Perlis (UniMAP), 2016)
Rule of Indonesian Republic No. 64, 2010 is about disaster mitigation in coastal area and
small island. It requires data of temperature and sea water surface increment. This paper
focuses on the ambient temperature and ...
A comparative study of quantum gates and classical logic gates implemented using Solid-State Double-Gate Nano-MOSFETs
(Universiti Malaysia Perlis, 2016)
The purpose of this paper is to compare the operations of silicon-based solid-state
quantum computer with classical logic gate made of double-gate (DG) nano-MOSFETs.
Quantum gates, such as quantum NOT gate, controlled-NOT ...
Material selection for CMOS compatible high Q and high frequency MEMS disk resonator using Ashby approach
(Universiti Malaysia Perlis, 2016)
In this paper, the most appropriate material for MEMS Disk resonator compatible
with CMOS technology is selected using the Ashby approach. Materials indices are
formulated based on three primary performance parameters, ...
Simulation of pem fuel cell performance using matlab
(Universiti Malaysia Perlis (UniMAP), 2016)
This paper presents the simulation of fuel cell performance using MATLAB. Firstly, a brief literature review about the fuel cell performance has been conducted. Then the analytical
model adopted to describe the polarization ...
Nature based dyes from blue pea flower as a potential sensitizer for dssc
(Universiti Malaysia Perlis (UniMAP), 2016)
The new technological way of Dye-Sensitized Solar Cell (DSSC) similar to photosynthesis
process has attracted much attention since its demonstrate a great potential due to the use of low-cost materials, ease of fabrication ...
Simulation of pem fuel cell activation losses with different electrolyte material based on tafel equation
(Universiti Malaysia Perlis (UniMAP), 2016)
This paper focuses on the charge transfer in fuel cell which is the electrons that created or
consumed are depending on the quickness of the electrochemical reaction that proceed
based on the suitable parameter. In Proton ...
Optimization the annealling time of membrane PSF19%DMF for palm oil mill effluent treatment
(Universiti Malaysia Perlis, 2016)
The membrane that produced is expected to be used for separation the particles that having size of 0.01 to 0.1 μm with MWCO range of 200-300 from the solution as industries
wastewater. The objective of research is to study ...
State feedback controller using pole placement method for linear boost converter to improve overshoot and settling time
(Universiti Malaysia Perlis (UniMAP), 2016)
Switched mode DC-DC converters are electronic circuits which convert a voltage from one
level to a higher or lower level voltage. This paper presents a new solution approach to
control DC-DC Boost converter. State-space ...