Search
Now showing items 241-250 of 255
Design single phase transformer
(Universiti Malaysia Perlis (UniMAP), 2011-04)
This project has presented the design of 1 kVA rated power, 200/100 V
and cable of 1.5 cross sectional area. The design of transformer coil starts
with the selection of number of turns of coil and selection of cable ...
Study of effectiveness PID controller for the selected case studies
(Universiti Malaysia Perlis (UniMAP), 2011-05)
PID (Proportional – Integral – Derivative) provides an efficient solution in many real-world control system problems. The main purpose of this final year project is to provide a general overview of the PID controller. This ...
Design and construct of 1.5kVA auto transformer
(Universiti Malaysia Perlis (UniMAP), 2011-04)
This project presents the design, analysis, and development of an
autotransformer to producing the output voltage range in 6V, 12V, 24V, 50V, 100V,
125V, 150V and 200V with the rated power of 1.5kVA. The design should ...
Study effect of climate factor on grounding resistivity around UniMAP campus
(Universiti Malaysia Perlis (UniMAP), 2011-04)
Soil resistivity data is the key factor in designing a grounding system for a specific performance objective like a climate factor. All soil conducts electrical current, with some soil having good electrical conductivity ...
Develop algorithm for forward clarke transformation
(Universiti Malaysia Perlis (UniMAP), 2011-06)
This project focused on verilog HDL design, simulation and waveform analysis for
Forward Clarke Transformation. Forward Clarke Transformation is used to control
motors in which it can convert 3 phase to two phase flow ...
RF conversion for power supply
(Universiti Malaysia Perlis (UniMAP), 2011-04)
A study on Radio frequency (RF) conversion to DC voltage has been
undertaking. RF was generated from mobile phone of about 900MHz and harvested by
a circuit called rectenna. The rectenna consists of antenna and rectifier. ...
Design and construct a three phase 5kVA, 1/0.415kV power transformer
(Universiti Malaysia Perlis (UniMAP), 2011-04)
The purpose of this Final Year Project is to understanding the knowledge and
theoretical of three phase transformer. The three phase transformer which is step-up from
415V to 1000V with a capacity 5kVA has been designed. ...
Estimation of step and touch voltage at 275/132 kV transmission line due to lightning stroke
(Universiti Malaysia Perlis (UniMAP), 2011-04)
Electrical transmission tower remains one of the important elements of today’s electrical power system. Transmission tower is designed to support conductors and ground wires of electrical power lines. Transmission line ...
Design, simulation and characterization of Moly Permalloy based electromagnetic sensor
(Universiti Malaysia Perlis (UniMAP), 2011-06)
This paper shows the design, simulation and characterization of Moly Permalloy based
electromagnetic sensor in MEMS software. The dimension of the device is minimized to the
smallest that the software can be simulated ...
Physical parameter optimization of cellulase by Aspergillus niger on solid-state fermentation of sawdust
(Universiti Malaysia Perlis, 2011-05)
Enzymatic hydrolysis of cellulose from lignocellulosic waste which is sawdust finds potential application in commercial production of cellulase enzyme. By using Design Expert 7.1.5, the effect of three physical parameters ...