An outgoing material handling improvement conducted in Perodua Engine Manufacturing Sdn. Bhd. (PEMSB) plant in Sg. Choh Rawang applies engineering theoretical knowledge into practice. Integration of both Toyota Production ...

Today, most of the traffic lights in Malaysia are controlled by Programmable Logic Control (PLC). This controller is chosen due to its low cost and user friendly programming language. The program could be modified to suit ...

Nowadays, communication is very important at any place, time and situation. The transmission of signal can be in wireless or cable (especially fiber optic that has more advantages than others cable for a long distance). ...

The fabrication of self-ordered anodic aluminum oxide (AAO) by anodization of Al foils and pure aluminum in sulfuric acid solution was investigated. The influences of anodizing variables, such as applied voltage, the ...

In this project, method of dynamic tensile test for brittle material is studied. The tensile test of brittle materials, i.e., ceramic, glass, plaster, concrete, and rock, are relatively difficult to performed in dynamic ...

The most important department in industry is the production department. The smooth in production flow beginning from the raw material to the product is important and need to maintain it. There are several improvements ...

This project is to generate power from the wind created by the vehicles on highway. That is used turbines generate power from the wind created by the vehicles that drive past them in opposite directions. This concept is ...

Nowadays, the optical technologies are very young in Malaysia. This technology still in the research to changes the sensor technologies. The detector requirement are very similar to those of optoelectronic sources; that ...

A triple concentric tube heat exchanger of approximately 4m length is fabricated using stainless steel tubes of 2 inches (5.08cm), 3 inches (7.62cm) and 4 inches (10.16cm) diameter respectively. The three different fluids ...