Search
Now showing items 1-10 of 599
An improvement study of outgoing materials handling at Perodua Engine Manufacturing Sdn. Bhd. (PEMSB) Plant in Sg Choh Rawang, Selangor
(Universiti Malaysia Perlis, 2009-05)
An outgoing material handling improvement conducted in Perodua Engine
Manufacturing Sdn. Bhd. (PEMSB) plant in Sg. Choh Rawang applies engineering
theoretical knowledge into practice. Integration of both Toyota Production ...
Development of intelligent traffic light
(Universiti Malaysia Perlis, 2007-04)
Today, most of the traffic lights in Malaysia are controlled by Programmable Logic
Control (PLC). This controller is chosen due to its low cost and user friendly programming language. The program could be modified to suit ...
Development of new OCDMA code
(Universiti Malaysia Perlis, 2007-05)
Nowadays, communication is very important at any place, time and situation. The transmission of signal can be in wireless or cable (especially fiber optic that has more advantages than others cable for a long distance). ...
Influence of H2 SO4 solution on formation of porous AAO thin film
(Universiti Malaysia Perlis, 2008-04)
The fabrication of self-ordered anodic aluminum oxide (AAO) by anodization of Al foils and pure aluminum in sulfuric acid solution was investigated. The influences of anodizing variables, such as applied voltage, the ...
Experimental analysis of splitting tensile test for brittle material
(Universiti Malaysia Perlis, 2009-05)
In this project, method of dynamic tensile test for brittle material is studied. The tensile test of brittle materials, i.e., ceramic, glass, plaster, concrete, and rock, are relatively difficult to performed in dynamic ...
Quality improvement of production line by using Hikarimono activity for automobile industry
(Universiti Malaysia Perlis, 2009-05)
The most important department in industry is the production department. The smooth in
production flow beginning from the raw material to the product is important and need to
maintain it. There are several improvements ...
Wind electric prime mover using air passing from vehicles in highway
(Universiti Malaysia Perlis, 2008-05)
This project is to generate power from the wind created by the vehicles on highway. That is used turbines generate power from the wind created by the vehicles that drive past them in opposite directions. This concept is ...
Drop simulation of notebook PC
(Universiti Malaysia Perlis (UniMAP), 2009-05)
Clear fluid detector using Optical technique
(Universiti Malaysia Perlis, 2007-04)
Nowadays, the optical technologies are very young in Malaysia. This technology still in the research to changes the sensor technologies. The detector requirement are very similar to those of optoelectronic sources; that ...
Measuring the temperature variation along the length of a triple concentric tube heat exchanger
(Universiti Malaysia Perlis (UniMAP), 2009-04)
A triple concentric tube heat exchanger of approximately 4m length is fabricated using
stainless steel tubes of 2 inches (5.08cm), 3 inches (7.62cm) and 4 inches (10.16cm)
diameter respectively. The three different fluids ...