School of Manufacturing Engineering (Articles): Recent submissions
Now showing items 121-125 of 125
-
The reduction of noxious emissions using urea based on Selective Non-Catalytic Reduction in small scale bio fuel combustion system
(Canadian Center of Science and Education, 2011-04-02)Selective Non-Catalytic Reduction (SNCR) of oxides of nitrogen (NOx) was studied experimentally by injecting different concentrations of aqueous urea solution in a pilot-scale Bio-fuel fired tunnel furnace at 3-4 % ... -
Spray characteristic of palm biofuel blends
(Universiti Malaya, 2010)The present numerical study on spray characteristic of biofuels, which is the blend of Refined, Bleached and Deodorized Palm olein (RBDPO) and Commercial Diesel Fuel (CDF) in gas turbine, is important. This type of study ... -
Experimental modal analysis of a golf clubface: Investigation of trampoline effect
(Vibromechanika, 2010-12)A complete modal analysis of a golf clubface has been presented in order to investigate the 'trampoline effect'. The availability of titanium golf drivers with thin, flexible faces opens up the opportunity to design the ... -
Removal of NOx and CO from a Burner system
(American Chemical Society, 2010-04-15)This paper presents the development of an emissions-controlling technique for oil burners aimed especially to reduce oxides of nitrogen (NOx). Another emission of interest is carbon monoxide (CO). In this research, a ... -
Comparison between ANSYS and CATIA simulation capability in simulating round shape diaphragm of MEMS piezoresistive pressure sensor
(Institute of Electrical and Electronics Engineering (IEEE), 2007-11)This paper presents a comparative study of MEMS Piezoresistive Pressure Sensor simulation using two different software of ANSYS and CATIA respectively. It is aimed to investigate the feasibility of utilizing CATIA software ...