Browsing School of Manufacturing Engineering (Articles) by Author "azwaniskandar@unimap.edu.my"
Now showing items 1-5 of 5
-
Chip formation studies in machining fibre reinforced polymer composites
Azwan Iskandar, Azmi, Dr. (Inderscience Enterprises Ltd., 2013)The use of end milling process for machining of fibre reinforced polymer composites has been widespread in various industries. Until recently, very little work has been reported with regard to characterisation of chip ... -
Fuzzy logic predictive model of tool wear in end milling glass fibre reinforced polymer composites
Azwan Iskandar, Azmi; Lin, Richard J.T.; Bhattacharyya, Debes (Trans Tech Publications., 2011-03)This paper presents development of tool wear prediction models in end milling of glass fibre reinforced polymer (GFRP) composites. Adaptive network based fuzzy inference system (ANFIS) was employed to accurately predict ... -
High-speed photographic study of chip formation during end milling of GFRP composites
Azwan Iskandar, Azmi; Lin, R.J.T; Bhattacharyya, D. (Trans Tech Publications, 2014)The chip forming process during end milling of glass fibre reinforced composites has been investigated in this study. The qualitative results from a high speed video camera has showed that discontinuous and fracturing of ... -
Machinability study of glass fibre-reinforced polymer composites during end milling
Azwan Iskandar, Azmi; Lin, Richard J.T.; Bhattacharyya, Debes (Springer-Verlag London., 2013-01)Machining of composite materials is usually performed to achieve required geometrical shapes and dimensional tolerances. However, machinability evaluation of glass fibre-reinforced polymer (GFRP) composites in end milling ... -
Tool wear prediction models during end milling of glass fibre-reinforced polymer composites
Azwan Iskandar, Azmi; Lin, Richard J.T.; Bhattacharyya, Debes (Springer-Verlag London., 2013-07)Composite products are often subjected to secondary machining processes as integral part of component manufacture. However, rapid tool wear becomes the limiting factor in maintaining consistent machining quality of the ...