Browsing Mohd Mustafa Al Bakri Abdullah, Prof. Dr. by Title
Now showing items 27-46 of 279
-
Comparative study on thermal, compressive, and wear properties of palm slag brake pad composite with other fillers
(Trans Tech Publications, 2011)The attractive performance-to-cost ratio associated with the incorporation of waste material in composite formulations used to produce brake pads has stimulated the idea of exploring the possible incorporation of additional ... -
The comparison between four PLCC packages and eight PLCC packages in personal computer (PC) using computational fluid dynamic (CFD), fluent software™ using epoxy moulding compound material (EMC)
(Trans Tech Publications, 2013)The paper present the three dimensional numerical analysis of heat and fluid flow through Plastic Leaded Chip Carrier (PLCC) packages in inline orientation horizontally mounted on a printed circuit board in a wind tunnel ... -
Comparison of geopolymer fly ash and ordinary Portland cement to the strength of concrete
(American Scientific Publishers, 2013-12)The aim of this study is to evaluate the effect of various fly ash: aggregate ratios by using fly ash (FA) based geopolymer compared to ordinary Portland cement (OPC) on the compressive strength of concrete. The different ... -
Comparison of original and sintered LUSI mud from East Java, Indonesia as raw material for making a geopolymer
(American Scientific Publishers, 2013-01)This paper presents the characterization of LUSI mud from East Java, Indonesia, as a potential raw material for making a geopolymer. Two types of LUSI mud were analyzed, i.e., original LUSI mud and LUSI mud that had been ... -
Comparison of Rubber as Aggregate and Rubber as Filler in Concrete
(Universiti Malaysia Perlis (UniMAP), 2007-06-09)This research will attempt to use rubber waste (tire rubber) replacement of coarse aggregate to produce early age concrete. An experiment will carry out to determine the strength of early age concrete with rubber waste ... -
Compressive strength and morphology of fly ash based geopolymer as artificial aggregate with different curing temperature
(Trans Tech Publications, 2014)This paper presented the compressive strength of geopolymer paste with different NaOH concentration and morphology analysis for sintered artificial aggregate. This artificial aggregate was produce based on mix design with ... -
Compressive strength and thermal conductivity of metakaolin geopolymers with anisotropic insulations
(IOP Publishing Ltd, 2020-02)This research investigated the properties of thermally insulating geopolymer prepared using waste filler (fibreboard and rubber) to act as anisotropic pore/insulation. The geopolymer matrix was synthesised using metakaolin ... -
Compressive strength of fly ash based geopolymer / glass fiber composite via filament winding
(Trans Tech Publications, 2014)In general, filament winding technique is used to fabricate the composite pipes using continuous fiber and matrix resin. In this study, fly ash based geopolymer resin composites reinforced by continuous glass fiber were ... -
Concrete aggregates from ceramic waste
(Universiti Malaysia Perlis (UniMAP)Pejabat Timbalan Naib Canselor (Penyelidikan dan Inovasi), 2008-12) -
Concrete Ceramic Waste Slab (CCWS)
(Kolej Universiti Kejuruteraan Utara Malaysia, 2006)The main focus of this research is to study the strength of concrete with ceramic waste as coarse aggregate. The source of ceramic waste are obtained from industrial in Malaysia. Presently, in ceramics industries the ... -
Concrete Ceramic Waste Slab (CCWS)
(Malaysian Invention & Design Society (MINDS), 2006-05-19)Concrete Ceramic Waste Slab (CCWS) was fabricated by mixing the composition of cement and ceramic wastes. The ceramic wastes will act as coarse aggregates in the mixture. This slab can be used as landscape products such ... -
Contribution of interfacial bonding towards geopolymers properties in geopolymers reinforced fibers: a review
(Multidisciplinary Digital Publishing Institute (MDPI), 2022-02-17)There is a burgeoning interest in the development of geopolymers as sustainable construction materials and incombustible inorganic polymers. However, geopolymers show quasi-brittle behavior. To overcome this weakness, ... -
Correlating composition design and properties of calcined kaolin geopolymeric powder
(American Scientific Publishers, 2013-12)This paper discussed the relation between composition design and properties of calcined kaolin geopolymeric powder. Geopolymeric powder was produced by applying the geopolymerization process. The solids-to-liquid ratios ... -
Correlation between Na 2SiO 3/NaOH ratio and fly ash/alkaline activator ratio to the strength of geopolymer
(Trans Tech Publications, 2012)Geopolymer requires an alkaline activator to induce it pozzolanic property and to accelerate the geopolymerisation process. The geopolymerisation process occurs due to the mixing of fly ash, sodium silicate and sodium ... -
Correlation of microstructure and flexural strength of fly ash geopolymer of varying molarities
(IOP Publishing Ltd, 2019-08)The present work studies and compares the flexural properties of fly ash geopolymer with varying molarity of sodium hydroxide (NaOH). Different molarities of NaOH solution (6M, 8M, 10M, 12M and 14M) are used to prepare the ... -
Correlation of the Na2SiO3 to NaOH Ratios and Solid to Liquid Ratios to the Kedah’s Soil Strength
(EDP Sciences, 2016)Geopolymer was used for the soil stabilization of Kedah’s soil at different ratios of solid to liquid and Na2SiO3 to NaOH in order to achieve the desired compressive strength. The geopolymerization process which produces ... -
Correlation of the processing parameters in the formation of granulated ground blast furnace slag geopolymer
(IOP Publishing Ltd, 2017-06)Geopolymers are inorganic materials with huge potential applications including building material, fire resistant materials, and agricultural construction materials. Various parameters influenced the final properties of ... -
Corrosion performance of reinforcement bar in geopolymer concrete compare with its performance in ordinary portland cement concrete: A short review
(Trans Tech Publications, 2013)Since decades ago, corrosion is the crucial factors for million dollars loss in construction industry. Corrosion of reinforcement bar in ordinary Portland cement (OPC) concrete is mainly due to chloride and acid attack and ... -
Corrosion studies of fly ash and fly ash-slag based geopolymer
(IOP Publishing Ltd, 2017-06)This paper presents the results of corrosion studies between Fly Ash Geopolymer (FG) paste and Fly Ash-Slag Geopolymer (FSG) paste. Geopolymer was made from aluminosilicate inorganic polymers mixed with the alkaline activator ... -
Cu-SiCp composites as advanced electronic packaging materials
(Trans Tech Publications, 2014)The demand for advanced thermal management materials such as silicon carbide particles reinforced copper matrix (Cu-SiCp) composites is increasing due to the stringent design requirement in the electronic packaging industries. ...