Search
Now showing items 11-20 of 24
Sintering effects on mechanical properties of Co-HA composite prepared by modified electroless deposition.
(Trans Tech Publications, 2014)
Co-HA composite produced using electroless deposition without conventional sensitization and activation treatment was studied with varying sintering temperature (1100°C, 1200°C and 1250°C). The particles size, bulk density, ...
The effect of pH on zinc phosphate coating morphology and its corrosion resistance on mild steel
(Trans Tech Publications, 2013)
Zinc phosphate coating is commonly used for corrosion protection of metallic materials, mainly mild steel. In this study, influence of the pH of phosphating bath on the surface morphology and corrosion resistance of zinc ...
Development of dense hydroxyapatite-ni by modified electroless deposition technique.
(Trans Tech Publications, 2014)
Ni deposited on HA powder was prepared by electroless plating process without sensitization and activation treatment. The deposited powder obtained was characterized by energy dispersive spectroscopy (EDX) and x-ray ...
Electrochemical measurement of PBS using cyclic voltammetry and AAO fabricated at ambient temperature and low potential
(Trans Tech Publications, 2013)
Anodic aluminium oxide fabricated at ambient temperature and low potential in phosphoric acid electrolyte was used as the working electrode for the electrochemical measurement of phosphate buffer saline under different pH ...
The influence of deposition temperature on the morphology and corrosion resistance of zinc phosphate coating on mild steel
(Trans Tech Publications, 2013)
The influence of phosphating temperature on the surface morphology and corrosion resistance of zinc phosphate coatings on mild steel was investigated. The phosphate layers were deposited on steel from phosphating bath at ...
Electrochemical corrosion behaviour of Mg-(Ca,Mn) sacrificial anodes
(Trans Tech Publications, 2013)
The aim of the study is to identify the effect of Ca in Mg-Mn alloy on electrochemical corrosion behavior for the development of high performance sacrificial anode. Mg alloys were fabricated by casting technique under an ...
Room temperature anodization of aluminum and the effect of the electrochemical cell in the formation of porous alumina films from acid and alkaline electrolytes
(VBRI Press, 2012)
Nanoporous alumina was produced by anodic oxidation of aluminum in both acidic and alkaline electrolytes. Previous reports indicate that nanoporous aluminais mainly produced from strongly acidic electrolytes, and with the ...
Effect of copper (II) acetate pretreatment on zinc phosphate coating morphology and corrosion resistance
(Springer US, 2013)
Zinc phosphate coating is widely used for corrosion protection of metallic materials, mainly mild steel. In the present study, the effect of pretreatment with copper acetate solution on zinc phosphate layer properties was ...
Effects of composition on the mechanical properties and microstructural development of dilute 6000 series alloys
(Asian Network for Scientific Information (ANSINET), 2012)
The aim of the present investigation is to study the effect of composition on the mechanical properties and microstructural development during thermal treatment of some dilute 6000 aluminium alloys. The alloys were based ...
Enhanced liquid-phase sintering of W–Cu composites by liquid infiltration
(Elsevier, 2014-03)
Full-density of consolidated W–Cu composites produced via conventional sintering method is difficult to achieve. In this work, fully-dense W–Cu composites were developed via the combination of the liquid phase sintering ...