Search
Now showing items 1-9 of 9
Research development of solder materials and its intermetallic compound (IMC) study
(Scientific.Net/Trans Tech Publications, 2012-12)
Nowadays, the formation and the subsequent growth of the intermetallic compounds (IMCs) and the development of new lead-free solder systems is a major issue in soldering. The excessive growth formation of intermetallic ...
Research advances of composite solder material fabricated via powder metallurgy route
(Scientific.Net/Trans Tech Publications, 2012-12)
Researches and studies on composite solder have been done by many researchers in an effort to develop viable lead-free solders which can replace the conventional lead-based solders as lead is considered as toxic. Solder ...
Effect of excess mgo mole ratio in a stoichiometric cordierite (2MgO·2Al2O3·5SiO 2) composition on the phase transformation and crystallization behavior of magnesium aluminum silicate phases
(The American Ceramic Society, 2011-05)
The effect of excess MgO, 2.0-4.0 mol ratios on the crystallization behavior and purity of Iμ-cordierite was investigated using X-ray diffraction (XRD), differential thermal analyzer, and TGA. Quantitative XRD, the Rietveld ...
Synthesis and characterization of xMgO-1.5Al2O3-5SiO2 (x = 2.6-3.0) system using mainly talc and kaolin through the glass route
(Elsevier B.V., 2011-10-03)
Three non-stoichiometric cordierite with compositions of xMgO-1.5Al2O3-5SiO2 (x = 2.6-3.0 mol) were synthesized using mainly talc and kaolin through the glass route. The densification and crystallization behaviors of these ...
Measurement on strain rate sensitivity and dynamic mechanical properties of various polymeric materials
(Trans Tech Publications, 2011)
Strain rate sensitivity and dynamic mechanical properties of polymeric materials are affected to a certain extent especially by the rate of loading. However, there is limited number of works reported on that particular ...
The effects of Al2O3 amount on the microstructure and properties of Fe-Cr matrix composites
(Springer, 2010-12)
Iron based matrix composites reinforced with 5 to 25 wt pct of Al2O3 particles were fabricated using the powder metallurgy method. The samples were prepared by mixing at 250 rpm for 30 minutes, uniaxially pressing at 750 ...
Effect of melting temperatures on the crystallization and densification of 2.8MgO•1.5Al2O3•5SiO2 glass-ceramic synthesized from mainly talc and kaolin
(Elsevier B. V., 2010-02-03)
Single phase α-cordierite with low sintering temperature was produced from 2.8MgO·1.5Al2O3·5SiO2 chemical formulation using mainly talc and kaolin. The effect of melting temperature to the densification, crystallization ...
Characterization and phase evolution of cordierite based glass synthesis from pure oxide and minerals
(Trans Tech Publications, Switzerland, 2011)
α Cordierite is very important phase in MgO-Al2O 3-SiO2 system because of their very outstanding thermal, chemical and electrical properties. In this presents study non-stoichiometry cordierite (MgO:Al2O3:SiO2 = 3:1.5:5) ...
Rietveld quantitative phase analysis of non-stoichiometric cordierite synthesised from mainly talc and kaolin: Effect of sintering temperature
(Trans Tech Publications, Switzerland., 2011)
Indialite or α-cordierite was synthesized by glass crystallization method using mainly talc and kaolin and with small amount of MgO, Al 2O3, SiO2 to compensate the chemical formulation of non-stoihiometric compositions of ...