Search
Now showing items 1-9 of 9
Predicting the localized flux distribution in three phase induction motor between different stator slot size
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-06)
A three phase induction motor differences of stator slot size is investigated in terms of its localized flux distribution. The search coil induced voltage method is used to analyze the flux distribution in the stator core. ...
Clear sky global solar irradiance on tilt angles of photovoltaic module in Perlis, Northern Malaysia
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-21)
The performance of a photovoltaic (PV) is highly influenced by its orientation and its tilt angle with the horizontal, due to the fact that both the orientation and tilt angle change the amount of solar radiation reaching ...
Potential of solar radiation and wind speed for photovoltaic and wind power hybrid generation in Perlis, Northern Malaysia
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-06)
This paper presents analysis of the solar radiation and wind speed characteristics in Perlis, Northern Malaysia for the year of 2006. The characteristics consist of daily and annual mean solar radiation and wind speed. ...
Measurement of overall power loss for different three phase 100kVA transformer core material
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-06)
This paper discussed result of an investigation towards the effect of using two different Cold Rolled Grain-Oriented (CRGO) Silicon Iron material to the 100kVA three phase distribution transformer. This experiment used M4 ...
Parameter determination of 0.5 hp induction motor based on load factor test - A case study
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-21)
The load can influence the efficiency of the induction motor. Even if the load has higher or less load factor, it can reduce the efficiency of an induction motor by several percentage. By knowing this, it is important that ...
Special designed universal power switching generator for power electronics studies
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-21)
This paper presents a specially designed power switching generator device that produces 4 types of waveforms; square-wave, sinusoidal PWM, quasi-sinewave or multilevel and high-frequency DC pulses with a total of 14 different ...
Special designed universal power switching generator simplifies power electronics studies
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-06)
This paper presents a specially designed power switching generator device that produces 4 types of waveforms; square-wave, sinusoidal PWM, quasi-sinewave or multilevel and high-frequency DC pulses with a total of 14 different ...
Harmonic monitoring at UniMAP distributed campus
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-06)
This paper an attempt has been made to monitor and analyze the harmonic distortions caused by certain typical non linear loads of an educational institution. The current and voltage harmonic distortion at PCC feeding office ...
Improvement of induction machine performance using power factor correction
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-21)
In this paper, a new approach to improve power factor (PF) and reduced total harmonic distortion (THDi) is generated by a single phase induction motor is proposed. By designing the necessary technique and methodology, the ...