Search
Now showing items 1-6 of 6
Loss prediction of induction motor using OPERA 2D software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
The paper discusses the factors which determine the
losses of induction motor. The loss mechanisms are
described in this paper and it is related to the
performance and design characteristics of induction
motor such as ...
Response of induction motor to balance voltage sags and momentary interruption
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper presents result of experimental study of induction motor behavior when subjected to voltage sags and interruption. Small induction motors were used to investigate this phenomenon. A shaffner “Profline 2100” EMC ...
Comparison of flux density between different thicknesses of non oriented electrical steel material using FEM software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Generally, 0.35mm has better performance than 0.5mm thickness of material in terms of losses reduction and money saving potential. This paper presents the comparison of the 0.35mm and 0.5mm thickness of non oriented ...
Induction motor behavior due to unsymmetrical and symmetrical faults
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
Voltage sags are generally caused by faults on transmission and/or distribution systems. The voltage produced may be either unsymmetrical or symmetrical, depend on type of faults. Unsymmetrical fault is faults caused by ...
Performance comparison different thickness of non oriented electrical steel material using analysis and performance chart from FEM software
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
With market condition today, the economics are
such that users and engineer are looking for the best
fit for the application at the most reasonable cost in
purchasing induction motors. Generally, 0.35mm
thickness of ...
The effect of different stator slot size on the stator copper loss
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
The input power to an induction motor is in the form of three phase electric voltages and currents. The first losses encountered in the machine are I2R losses in the stator winding. The stator copper loss occurs when the ...