Search
Now showing items 1-6 of 6
In-plane flux distribution in the mix 60o- 45o T-joint of three phase transformer core
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper describes the result of measurement of inplane
flux distribution on 100kVA 3phase distribution
transformer assembled with the mix 60o- 45o T-joint and
mitred lap corner joint with stagger yoke of 10mm. ...
Optimization of photovoltaic module electrical characteristics using genetic algorithm
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper presents the optimization of PV module
electrical characteristics using genetic algorithm (GA).
A mathematical modeling was used to characterize the
electrical characteristics of PV module. A 180 W, 30
V, ...
Simulation of flux distribution and loss calculation at three-phase transformer core with the mix 60o-45o T-joint
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper describes the result of simulation of flux
distribution on 100kVA 3phase distribution transformer
assembled with 23o T-joint and mitred lap corner joint with
stagger yoke and limb for one lamination. The ...
High side MOSFET driver design using discrete components for low voltage applications
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper presents the design of a high-side N-channel MOSFET driver using discrete components for low voltage applications, ranging from 3V up to 24Vdc operation. Special level shifting technique is used to increase the ...
Investigation of power factor on harmonic effect due to types of voltage source
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper discussed about power factor on harmonic effect due to types of voltage source. Usually, the voltage source is sinusoidal. But in actually, the condition of the load is has voltage sources through the elements ...
Analysis flux on transformer core lamination assembled with mix between 60o- 45o T-joint using 2DFEM
(Universiti Malaysia Perlis (UniMAP), 2010-06-02)
This paper describes analysis 2DFEM on 100kVA 3phase distribution transformer assembled with mix between 60-45 T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The simulation involves the ...