Recycled concrete aggregates mainly differ from natural aggregates in that they are composed of two different materials: natural aggregate and cement mortar attached. There is no general study about the quantitative ...

Nowadays people are paying more attention to the sustainability in construction and to improve the quality of the concrete using recycle or waste product. As in this research, the fine aggregates in concrete are replace ...

Lightweight concrete defined that is a type of concrete that is use lightweight aggregates and more lighter with low density than the conventional concrete. The main objectives of this research were to produce a good quality ...

Improper slope analysis design might cause slope failure which has been acknowledge as one of the most frequent disaster that can lead to great loss of properties and life. There are many types of slope stabilization ...

As a developing country, construction is the one of main incomes producing in Malaysia. Huge amount of demolition waste were produced from these activities. In Malaysia, the construction waste has cause a significant ...

Premix waste (PW) as a partial replacement of aggregate in concrete. Three percentages to investigate PW as a partial replacement of aggregate which is 20%, 30% and 50% of PW. Slump test and compressive test will carried ...

Study of slope stability is important for further purposed in construction and other infrastructure. Assessment stability on man-made slope is essential part because man-made slope exists all over the world. The objective ...

Nowadays, a new development of lightweight concrete has been introduced to use in construction. This is because lightweight concrete present an essential decrease in density if compared with normal concrete. The objective ...

This project presents the result of brick masonry strength depends on different bonding follow by the type brick and to determine the crack pattern at the masonry wall. The arrangement was used in this research is stretcher ...

The defect of concrete structures is a common phenomenon in the construction industry. Structural defect can occur in buildings and other structural parts and it is very difficult to detect and unknown cause. This study ...