Browsing Kamarudin Hussin, Brig. Jen. Datuk Prof. Dr. by Subject "Geopolymer"
Now showing items 1-20 of 61
-
Alteration in the microstructure of fly ash geopolymer upon exposure to elevated temperatures
(Trans Tech Publications, 2013)This paper represents the mechanical and microstructure changes in geopolymeric material synthesized by the alkali activation of locally source fly ash at high temperatures of 400, 600 and 800 °C. The high compressive ... -
Characterization of LUSI mud volcano as geopolymer raw material
(Trans Tech Publications, 2012)The mud of mud volcano samples were collected from an eruption site named 'LUSI' (Lumpur "mud" -Sidoarjo), East Java, Indonesia for characterization. Analysis showed that, the major constituents of mud are SiO 2 and Al 2O ... -
Characterization of LUSI mud volcano as geopolymer raw material: A review
(Universiti Malaysia Perlis (UniMAP), 2012-06-18)This paper summarizes the current knowledge about the potential of LUSI mud volcano, East Java, Indonesia as a raw material in geopolymer. Previous experimental study shows that the LUSI mud has a good performance when 5% ... -
Chemical and physical characterization of boiler ash from palm oil industry waste for geopolymer composite
(Syscom 18 SRL/ SC BIBLIOTECA CHIMIEI SA, 2013-12)The characterizations of boiler ash waste from waste of palm oil industry were performed. The boiler ash was obtained from the boiler in the palm oil processing factory. The chemical and physical characterization has been ... -
Chemical reactions in the geopolymerisation process using fly ash-based geopolymer: A review
(American-Eurasian Network for Scientific Information (AENSI Publisher), 2011-07)The development of our world, demanding the power supply which is produced by combustion of coal. Unfortunately, the million of tons of fly ash and related-products have been generated. To overcome these problems, fly ash ... -
Comparison of geopolymer fly ash and ordinary Portland cement to the strength of concrete
(American Scientific Publishers, 2013-12)The aim of this study is to evaluate the effect of various fly ash: aggregate ratios by using fly ash (FA) based geopolymer compared to ordinary Portland cement (OPC) on the compressive strength of concrete. The different ... -
Comparison of original and sintered LUSI mud from East Java, Indonesia as raw material for making a geopolymer
(American Scientific Publishers, 2013-01)This paper presents the characterization of LUSI mud from East Java, Indonesia, as a potential raw material for making a geopolymer. Two types of LUSI mud were analyzed, i.e., original LUSI mud and LUSI mud that had been ... -
Compressive strength and morphology of fly ash based geopolymer as artificial aggregate with different curing temperature
(Trans Tech Publications, 2014)This paper presented the compressive strength of geopolymer paste with different NaOH concentration and morphology analysis for sintered artificial aggregate. This artificial aggregate was produce based on mix design with ... -
Compressive strength of fly ash based geopolymer / glass fiber composite via filament winding
(Trans Tech Publications, 2014)In general, filament winding technique is used to fabricate the composite pipes using continuous fiber and matrix resin. In this study, fly ash based geopolymer resin composites reinforced by continuous glass fiber were ... -
Correlation between Na 2SiO 3/NaOH ratio and fly ash/alkaline activator ratio to the strength of geopolymer
(Trans Tech Publications, 2012)Geopolymer requires an alkaline activator to induce it pozzolanic property and to accelerate the geopolymerisation process. The geopolymerisation process occurs due to the mixing of fly ash, sodium silicate and sodium ... -
Development of pilot plant for novel geopolymer brick making machine
(American-Eurasian Network for Scientific Information, 2013)With rapid growing country's development and rose in construction activity, rising demand of building materials and increased construction wastes have encouraged the development of new building materials. Geopolymer based ... -
Effect of Crumb Rubber on compressive strength of fly ash based Geopolymer concrete
(EDP Sciences, 2016)This study explores the effect of different percentage of crumb rubber on compressive strength of fly ash based geopolymer concrete. This research attempted to produce rubberized geopolymer concrete as an environmentally ... -
Effect of curing regimes on metakaolin geopolymer pastes produced from geopolymer powder
(Scientific.Net/Trans Tech Publications, 2012-12)The properties of metakaolin geopolymer paste are affected by the alkali concentration, the initial raw materials, solidification process, and amount of mixing water as well as the curing conditions. This study aimed to ... -
The effect of curing temperature on physical and chemical properties of geopolymers
(Elsevier BV, 2011)Fly ash-based geopolymers required heat to increase the geopolymerization process in order to obtain higher compressive strength. As such, geopolymer samples were prepared using different curing temperatures (room temperature, ... -
The Effect of Different Ratio Bottom Ash and Fly Ash Geopolymer Brick on Mechanical Properties for Non-loading Application
(EDP Sciences, 2017)This paper studies the finding of strength and water absorption of geopolymer bricks using bottom ash and fly ash as a geopolymer raw material for non-loading application with minimum strength. The study has been conducted ... -
Effect of fly ash/alkaline activator ratio and sodium silicate/NaoH ratio on fly ash geopolymer coating strength
(Trans Tech Publications, 2013)Fly ash geopolymer coating material potential used to protect surface used in exposure conditions. Ratio of fly ash/alkaline activator and Na₂SiO₃/NaOH play important parameter on determining the best flexural strength of ... -
Effect of Glass Reinforced Epoxy (GRE) pipe filled with Geopolymer Materials for Piping Application: Compression Properties
(EDP Sciences, 2016)The aim of this paper is to achieve the highest compressive strength of glass reinforced epoxy pipe with the geopolymer filler content of weight percentage that were used in glass reinforced epoxy pipe. The samples were ... -
Effect of NaOH concentration on microstructure of boiler ash based geopolymer
(Trans Tech Publications Ltd., 2015)Boiler ash is one of the waste material from palm oil processing industry and it was widely available. The role of alkaline activator in geopolymer is important for its mechanical properties. NaOH and sodium silicate ... -
Effect of Solids-To-Liquids, Na2SiO3-To-NaOH and Curing Temperature on the Palm Oil Boiler Ash (Si + Ca) Geopolymerisation System
(MDPI AG, 2015)This paper investigates the effect of the solids-to-liquids (S/L) and Na2SiO3/NaOH ratios on the production of palm oil boiler ash (POBA) based geopolymer. Sodium silicate and sodium hydroxide (NaOH) solution were used as ... -
Effect on strength and hardness of clay ceramic substrate after treatment using koalin based geopolymer glaze
(Trans Tech Publications, 2014)Geopolymerization is an alternative for ceramic industry by using clay based material such as kaolin or calcined kaolin geopolymer. Geopolymer paste is initially produced by alkaline activation of calcined kaolin with NaOH ...