Browsing Journal Articles by Subject "Taguchi"
Now showing items 1-6 of 6
-
Comparison between single and multi gates for minimization of warpage using taguchi method in injection molding process for ABS material
(Trans Tech Publications, 2013-12)In this study, a mold is designed in single and dual type of gate in order to investigate the deflection of warpage for thick component in injection molding process. Autodesk Moldflow Insight software was used as a medium ... -
Improving warpage on thin shallow parts in two-plate moulds with conformal cooling channels
(Praise Worthy Prize S.r.l., 2013-03)Nowadays, the trend of consumer products designed is getting smaller and most of cover is made from plastic which was produced by using injection molding process. Thus, the demand of thin shallow plastic parts in global ... -
Investigation on the effects of machining performances for milling Al-30%/SiC-70% infiltrate metal matrix composites
(Universiti Malaysia Perlis (UniMAP), 2022-03)The unique properties of Al-30%/SiC-70% Metal Matrix Composite (MMC) such as lightweight, high strength, and wear resistance has made it as an alternative material for precision machinery parts. Owing to the presence of ... -
Optimization of compacting process for Porous Ti-6Al7Nb alloys with Magnesium as a space holder by using Taguchi Method
(Universiti Malaysia Perlis (UniMAP), 2022-10)The optimization of compacting process for porous titanium niobium (Ti-6Al-7Nb) alloys with magnesium as a space holder prepared by powder metallurgy process was studied to analyze the significant porosity required in ... -
Taguchi Method for p-MOS threshold voltage optimization with a gate length of 22nm
(Universiti Malaysia Perlis (UniMAP), 2023-01)This paper describes the virtual design of a 22nm gate length p-type metal oxide semiconductor, PMOS. Silvaco, TCAD tools were used to fabricate the device design and to characterize the device’s electrical properties. ... -
Warpage analysis with straight drilled and conformal cooling channels on front panel housing by using taguchi method
(Trans Tech Publications, 2014)The challenging in injection molding process is to get the uniform thermal distribution on the molded parts during the cooling stage which is mainly depend on the design of the cooling channels in injection mold. Poor ...