• Login
    View Item 
    •   DSpace Home
    • Final Year Project Papers & Reports
    • School of Manufacturing Engineering (FYP)
    • View Item
    •   DSpace Home
    • Final Year Project Papers & Reports
    • School of Manufacturing Engineering (FYP)
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Evaluated the temperature of Rangue Hilsch Vortex tube performance using Taguchi method

    Thumbnail
    View/Open
    Abstract,Acknowledgement.pdf (403.9Kb)
    Introduction.pdf (244.8Kb)
    Literature Review.pdf (769.5Kb)
    Methodology.pdf (467.6Kb)
    Results and Discussion.pdf (419.9Kb)
    Conclusion and Recommendation.pdf (45.15Kb)
    Refference and Appendics.pdf (567.7Kb)
    Date
    2016-05
    Author
    Law, Seong Seng
    Metadata
    Show full item record
    Abstract
    The output performances of vortex tube are mainly depending on the vortex tube parameters (length, diameter and angle). A study was carried out to investigate the relationship between the vortex tube parameters and the output performance of a vortex tube. Therefore, the objective is to study the effect of those vortex tube parameters on the output air temperature. The lowest temperature to be produced must be less than 10°C then Taguchi method was used to optimize the vortex tube parameters. So that the length, diameters and angle can be variable between 100mm and 200mm, 2mm and 8mm, 20° and 60°, respectively. Taguchi standard L9 orthogonal array was used to layout the experiment. From the analysis, the predicted optimal parameters was found in minimum temperature 1.4°C was 20° for valve angle, 6mm cold valve diameter, 6mm inlet valve diameter with 7 bar air pressure and maximum temperature 36.6°C was 20° valve angle, 6mm cold valve diameter, 5mm inlet valve diameter with 7 bar air pressure. Confirmation test was conduct to compare the result and shows that the angle generator was the most significant factors among other.
    URI
    http://dspace.unimap.edu.my:80/xmlui/handle/123456789/69833
    Collections
    • School of Manufacturing Engineering (FYP) [338]

    Atmire NV

    Perpustakaan Tuanku Syed Faizuddin Putra (PTSFP) | Send Feedback
     

     

    Browse

    All of UniMAP Library Digital RepositoryCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    Atmire NV

    Perpustakaan Tuanku Syed Faizuddin Putra (PTSFP) | Send Feedback