| dc.contributor.author | Praveen, Balakrishnan | |
| dc.date.accessioned | 2015-07-09T04:04:39Z | |
| dc.date.available | 2015-07-09T04:04:39Z | |
| dc.date.issued | 2009-04 | |
| dc.identifier.uri | http://dspace.unimap.edu.my:80/xmlui/handle/123456789/40236 | |
| dc.description | Access is limited to UniMAP community. | en_US |
| dc.description.abstract | A triple concentric tube heat exchanger of approximately 4m length is fabricated using
stainless steel tubes of 2 inches (5.08cm), 3 inches (7.62cm) and 4 inches (10.16cm)
diameter respectively. The three different fluids used in the heat exchanger are hot water,
cold water and normal tap water. The fluids can flow in parallel flow or counter flow
configuration. This project deals with the measurement of temperature variation along the
length of the heat exchanger for different fluids using T-type thermocouples and Agilent
Data Acquisition System. The temperature variations of different fluids along the length of
heat exchanger is reported. These results are helpful for determining the effectiveness of the heat exchanger. CFD simulation results are also presented in the report. However no direct comparison is made because of the different operating conditions used in the simulation. | en_US |
| dc.language.iso | en | en_US |
| dc.publisher | Universiti Malaysia Perlis (UniMAP) | en_US |
| dc.subject | Heat exchanger | en_US |
| dc.subject | Heat transfer | en_US |
| dc.subject | Concentric tube | en_US |
| dc.subject | Stainless steel tubes | en_US |
| dc.title | Measuring the temperature variation along the length of a triple concentric tube heat exchanger | en_US |
| dc.type | Learning Object | en_US |
| dc.contributor.advisor | Prof. Madya Dr. Ghulam Abdul Quadir | en_US |
| dc.publisher.department | School of Mechatronic Engineering | en_US |
