Search
Now showing items 31-39 of 39
Performance of gas turbine cycle for combined cycle power plant
(Universiti Malaysia Perlis, 2009-05)
The gas turbine based power plant is characterized by its relatively low capital cost
compared with the steam power plant. It has environmental advantages and short
construction lead time. However, conventional industrial ...
Analysis of heat exchanger concentric tube by Finite Element Method
(Universiti Malaysia Perlis, 2009)
The objective for this project is to study the performance of heat exchanger in parallel flow
and counter flow. This experiment using three different temperature of water like cold, hot
and normal temperature. The governing ...
Fast transient thermal analysis of Fourier and non-Fourier heat conduction
(Elsevier Ltd., 2007-10)
In this paper, asymptotic waveform evaluation (AWE) has been successfully used for fast transient characterization of Fourier and non-Fourier heat conduction. The Fourier and non-Fourier equations are reduced to a system ...
Analysis of stress concentration factor in bolted joint using finite element method
(University of Malaya, 2008)
Bolted joints are widely used in industries e.g. pressure vessels, automobiles, machine tools, home appliances etc., thus it is becoming increasingly important to accurately predict the behavior of bolted joints. The ...
Design and fabrication of triple concentric pipe heat exchanger
(Universiti Malaysia Perlis, 2009-10-11)
The objective of this piper is to dsign and fabricate a triple concentric-pipe heat exchanger to be used for the fluid
flow and heat transfer analysis of parallel flow and counter flow arrangement of fluids. The three ...
Analysis of a Three-Fluid cocurrent and countercurrent parallel flow heat exchanger
(Universiti Malaysia Perlis, 2009-10-11)
The temperature variation of the fluids in a three-fluid cocurrent and countercurrent parallel flow heat exchanger is measured and compared with the results obtained from the finite element analysis. It is found that finite ...
Flow analysis for powered inhaler accessory device
(Universiti Malaysia Perlis, 2009-05)
The aim of the study is to analyze the flow characteristics of the powered inhaler accessory device (PIAD), ranging from vortex development and two phase mixture of the inhaler drug. Computational Fluid Dynamics (CFD) ...
FEM analysis and experimental validation of flashless cold forging of autonomous underwater vehicle hubs
(Universiti Malaysia Perlis, 2009-10-11)
In this paper three-dimensional FEM analysis and experimental flashless cold forging of aluminum front and back hubs of Autonomous Underwater Vehicle (AUV) propeller is presented. The rigid-plastic finite element
simulation ...
Fast transient solution of a two-layered counter-flow microchannel heat sink
(Emerald Group Publishing Limited., 2009)
Purpose: The purpose of this paper is to apply asymptotic waveform evaluation (AWE) to the transient analysis of a two-layered counter-flow microchannel heat sink. Design/methodology/approach: A two-layered counter-flow ...