Now showing items 394-413 of 437

    • Study on modified sand filtration towards water quality of wet market waste water 

      Mohammad Nasri, Jamil (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2015-06)
      Malaysia’s wet market scenery synonyms with unpleasant odour, dirty environment and the pathogen development. The purpose of this study is to apply physical treatment as a pre-treatment of waste water using a sand filtration ...
    • Study on performance of coconut coir fiber, rice husk and sawdust as noise abatement materials 

      Laila Mardiah, Deraman (Universiti Malaysia Perlis (UniMAP), 2014-06)
      Noise can cause a few types of effect to human health, especially in hearing like hearing loss. Indoor noise pollution comes from many sources and places. The research focus on the sound reduction wall surface material ...
    • Study on physical and geotechnical properties of Jana Manjung coal ash mixtures 

      Muhd Al-Hafiz, Muhammad Yusoff (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2013-06)
      Most of coal-burning power plant produced residue by-product after burning process such as fly ash and bottom ash with approximate production ratio of 80% fly ash and 20% bottom ash. In the past, most of the coal burning ...
    • Study on physical, morphological and strength properties of Jana Manjung ash mixture 

      Asyraf Nasuha, Mohd Yunus (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2013-06)
      Raw material like coal has been used in Malaysia to generate or produce electricity since 1988.The burning of coal producing excessive waste and directly cause of significant economic and environmental problem. The ash ...
    • Study on properties of cement composite with partial substitution of bottom ash as cement 

      Mohd Redzuan, Talib (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2014-06)
      The bottom ash is generated from the bottom of the incinerator and commonly known as trash consists of common items we used in daily life, Municipal Solid Waste (MSW). The sample of bottom ash has been taken from XCN ...
    • Study on quality of wastewater from car wash premises 

      Izzati Syazwani, Ahmad Talat (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2011-04)
      Car wash wastewater (CWW) normally contains oil and grease, rubber, paints, phosphate, dust and sand and organic matter. The wastewater runoff from the car enters the gutters gone into the storm water system. The wastewater ...
    • A study on safety during precast concrete installation 

      Muhammad Qayyim, Suhaimi (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2014-05)
      The safety aspect is very important in construction projects. Any construction projects such as the installation of precast concrete will accident if they are not concerned about safety aspect during the process of making ...
    • A study on soil characteristic of clay in Perlis 

      Raja Asyman, Raja Badrul Hisham (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2012-05)
      Soils are the form of many layers that cover up the Earth’s surface. As for an environmental engineer soil is an invention of the surroundings and its creation is a function of climate, organisms, parent rock or material, ...
    • A study on solid waste Management at Kg. Jelempok, Arau 

      Shazryenna, Dalang (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2010-04)
      Solid waste management has six main functional elements. There are Waste Generation, Storage, Collection, Transportation, Recycle and Process and Disposal. Problem can occur in any stage of the management. In Malaysia, ...
    • Study on sugarcane waste characteristics as a clean energy source 

      Chan, Shan Chuan (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2012-05)
      Sugarcane bagasse (SCB) was pyrolyzed in a fixed-bed tubular reactor under different pyrolysis conditions to determine the effects of reactor operating temperature (400 °C to 500 °C), heating rate (50 °C/min to 70 °C/min), ...
    • Study on the characteristic of municipal solid waste from Perlis disposal site 

      Rohada, Saad (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2011-05)
      Increasing population levels, rapid economic growth and rise in community living standard accelerates the generation rate of municipal solid waste (MSW) in Perlis. The objectives of this study are to determined the physical ...
    • Study on the different arrangement of brick masonry wall between three type of bricks 

      Khairul Nusrat, Kamal (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2013-06)
      This project presents the result of brick masonry strength depends on different bonding follow by the type brick and to determine the crack pattern at the masonry wall. The arrangement was used in this research is stretcher ...
    • Study on the fire resistance of municipal solid waste bottom ash block 

      Mohd Rafique, Mohd Nasir (Universiti Malaysia Perlis (UniMAP), 2015-06)
      The bottom ash is a waste material obtained from the Municipal Solid Waste Incinerator, Langkawi. To reduce the waste material in this world, reuse is one of the solutions. Therefore, the waste product will not be as harmful ...
    • Study on the influence of attached mortar content on the properties of recycled concrete aggregate 

      Nursyazwani, Zainudin (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2013-06)
      Recycled concrete aggregates mainly differ from natural aggregates in that they are composed of two different materials: natural aggregate and cement mortar attached. There is no general study about the quantitative ...
    • Study rain influence of chemical water quality in Sungai Perlis 

      Nurul Huda, Abdullah (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2011-05)
      Environmental pollution problem especially water sources pollution become most of public interest. Rainfall water always content of mixtures of chemicals depends on the characteristic of rainfall area. This is because the ...
    • Study the accumulation of nutrients and heavy metals in soil media in sub-surface flow (SSF) constructed wetland 

      Siti Yashidah, Mohamed Yazid (Universiti Malaysia Perlis (UniMAP), 2012-05)
      This study focus on the accumulation of heavy metals (Fe, Zn, Mn and Ni) and nutrients (PO4 3- and NH3-N) in the soil media of the sub surface flow constructed wetland. This study was conducted by a lab-scale sub surface ...
    • Sustainable building material – Using organic matter focusing on ceiling 

      Mohd Zulkifly, Mohd Shariff (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2011-04)
      Sustainable development is development that meets the needs of the present without compromising the ability of future generation to meet their own needs (World Commission on Environment and Development, 1987). Agriculture ...
    • Synthesis of photocatalyst Zinc Oxide for the treatment of organic contaminants 

      Norzihan, Ibrahim (Universiti Malaysia Perlis (UniMAP), 2014-06)
      Phenol is the one of the hazardous contaminant that contains in wastewater commonly in industrial effluent. The unique properties of nanoparticles size of zinc oxides have been paid more attention due to its photosensitive ...
    • Synthesis of pigment using waste sludge from rubber-based industry 

      Aki Ikhwan, Mohd (Universiti Malaysia Perlis (UniMAP), 2014-06)
      In the new global economy towards sustainable manufacturing, the industries need to produce products through economic processes while minimizing the negative impacts to the environment through recycling, reducing or utilizing ...
    • A system for early budgeting cost of highway maintenance In Malaysia 

      Abdul Muhaimin, Mohd Yunus (Universiti Malaysia Perlis (UniMAP)School of Environmental Engineering, 2014-07)
      This project presents the process of developing an expert system to make an early budgeting for the cost of highway maintenance in Malaysia. Based on interviews with department of public works (PWD) , there are several ...