Search
Now showing items 1-10 of 15
The thermal expansion behaviors of Cu-SiCp composites
(Trans Tech Publications, 2013)
The demand for advanced thermal management materials such as silicon carbide reinforced copper matrix (Cu-SiCp) composites is increasing due to their high thermal conductivity and low CTE properties. However, the weak ...
Synthesis and characterization of electroless copper coated SiC particles
(Trans Tech Publications, 2013)
Silicon carbide reinforced copper matrix (Cu-SiCp) composites fabricated via the conventional powder metallurgy methods have inferior thermophysical properties due to the weak bonding between the copper matrix and the SiCp ...
The corrosion studies of powder metallurgy Co-Cr-Mo (F-75) alloy
(AENSI Publisher All rights reserved, 2013-10)
Co-Cr-Mo (F-75) alloy was investigated for biomedical application due to its mechanical properties and good corrosion resistance. This study has been focusing on the corrosion behavior of PM Co-Cr-Mo alloy. The Co-Cr-Mo ...
Corrosion behavior of Al-Cu-Ni-Y alloys
(Trans Tech Publications, 2013)
Al based alloy has been widely used in various industries. This research paper aims at the investigation onto the effect of the percentage of Cu and Ni alloying elements in the corrosion behavior of Al-Cu-Ni alloys. The ...
Effect of anodizing voltage on the morphology and growth kinetics of porous anodic alumina on Al-0.5 wt% Mn alloys
(Trans Tech Publications, 2014)
In this study, the effect of anodizing voltage on the morphology of porous anodic alumina and growth kinetics of anodizing of aluminium manganese alloy was reported. It was found that the increasing anodizing voltage affect ...
Comparison study in consolidation of yttria reinforced iron-chromium composites using conventional and microwave sintering technique
(Trans Tech Publications, 2014)
This research is focused on studying the density and mechanical properties of iron-chromium composites consolidated by innovative rapid microwave sintering technology against conventionally sintered counterparts using slow ...
The effect of electrolyte temperature on formation of porous aluminium oxide films in anodising process
(AENSI Publisher All rights reserved, 2013-10)
A porous aluminium oxide film formed on aluminium was prepared in a mixed electrolyte of phosphoric acid and acetic acid solution. The morphology, growth and thickness of the film were investigated. The anodising process ...
Effect of manganese content on the fabrication of porous anodic alumina
(Hindawi Publishing Corporation, 2012)
The influence of manganese content on the formation of well-ordered porous anodic alumina was studied. Porous anodic alumina has been produced on aluminium substrate of different manganese content by single-step anodizing ...
Effect of electrolyte concentration on the growth of porous anodic aluminium oxide (AAO) on Al-Mn alloys
(Trans Tech Publications, Switzerland, 2012-12)
In this study, the effect concentration of electrolyte on pore nucleation process during anodizing was investigated. It was found that the concentration of oxalic acid influenced the morphologies and regularities of porous ...
Effect of heat treatment on microstructure and corrosion behavior of Az91d magnesium alloy
(Trans Tech Publications, 2013)
An AZ91D ingot in the as-cast condition was homogenized by heat treatment process. Then, the microstructures produced and corrosion behaviour after heat treatment was studied in detail. As-cast AZ91D was recrystallize by ...