School of Manufacturing Engineering (Theses)
Browse by
Recent Submissions
-
Development of dynamic response analysis for flexible lightweight vehicle chassis
The development in vehicle design is on-going growth. Many new inventions appeared to produce a better vehicle. There is also an effort to replace steel with a lighter weight of material such as aluminium in order to reduce ... -
Parametric identification of flexible beam system using evolutionary algorithm
An application of flexible structures in engineering is spread extensively due to lightweight property and technical importance. Before implementing the system, the dynamic behavior of the system needs to be studied by ... -
Design and development of integrated transplanter and weedermmachine for system of rice intesification (SRI) cultivation in Malaysia
System of rice intensifications (SRI) was practiced by community in Lembah Organik Lentang, Kampung Lentang since 2010. Throughout the years, the paddy plots began to grow in number. Since most of the SRI practices needed ... -
Critical components identification using analytic hierarchy process - a case study towards product design improvement
Failure of product during its operation may result unsatisfied customer. In order to maintain the high value of product, proper action such as maintainability measure and reliability is one of crucial part during product ... -
Modeling and investigation of combined darrieus and vane design vertical axis wind turbine
Wind energy is one of the potential sources of renewable energy because of its abundance in the atmosphere. It is available in different scales of high, medium and low-velocity ranges. Wind power is a major source of ... -
New empirical formula for reduction factor of head garment
Pressure garment is one of non-surgical method in pressure therapy treatment, which uses pressure as healing mechanism for hypertrophic scars caused from burn injuries. Previous studies proposed a fabrication method based ... -
Fundamental research with respect to thermal phenomena of micro EDM
(Universiti Malaysia Perlis (UniMAP)School of Manufacturing Engineering, 2014)Material removal in electrical discharge machining, EDM is by thermal erosion. Therefore, information on thermal phenomena of the process is required for further analyses of the process. Currently, demands on micro ...
RSS 1.0