Now showing items 41-60 of 218

    • Study of lightning backflashover performance for 132 kV transmission line using ATP-EMTP 

      Nur Farhana, Rashid (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      Lightning has been a major concern to the power system researchers as it may cause damage to the connected electrical equipment especially to the transmission line. One of the event that will cause lightning overvoltage ...
    • An investigation of harmonic impacts from asd under sinusoidal supply voltage 

      Tan, Kheng Hui (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-06)
      This project basically is investigates the effect of type of supply voltage to ASD three phase and single phase. The type of voltage sources are step, ramp, repeating sequence and sine wave. A complete analytical model ...
    • The lightning detector and location 

      Mohd Syakirin, Ahmad (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      Lightning is the occurrence of changes in electricity in the air and produce a large voltage energy .Lightning strikes starts by the movement of light, followed by a loud sound of thunder. This characteristic is important ...
    • Real time pricing cost and value of wind generation 

      Thiam, Ming Chang (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      Wind energy is expected to play an important role in electrical energy generation. This project presents an economic feasibility study of a wind power generation plant project in Kuala Perlis. The study site of this ...
    • Impedance bus matrix formulation tutorial software 

      Tang, Chiok Chew (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-04)
      The bus impedance matrix is an excellent network description use in the solution of faulty networks. Unlike traditional network analysis, a bus impedance matrix usually used simplified notation such as a one-line diagram ...
    • Temperature and humidity monitoring and control of a poultry incubator 

      Tiong, Li Hwa (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      This project discuss about the temperature and humidity monitoring and control of a poultry incubator. Temperature and humidity are the main parameter to the success of the incubator during the hatching process. To improve ...
    • Development of a wind generator system 

      Yeoh, Zee How (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-04)
      Fifty years ago, a wind power industry did not exist. Today, it not only exists but it flourishes. This development is surprising because it has involved the spread of a radical new technology through a sector that is ...
    • Development of soft starter for single phase ac induction motor 

      Mohd Shafiq, Bahari (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-06)
      AC voltage controllers are used as soft starters in induction motors for starting and to adjust its speed. Due to the increased number of induction motors in industry applications and residential appliances especially air ...
    • The effect of passive filter on the 3rd, 5th and 7th harmonic in nonlinear load 

      Mohd Hanif, Roslan (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      This project discusses the effect of passive filter on 3rd, 5th and 7th harmonic in nonlinear load. The passive filter considered is the single tuned harmonic filter. In the design of the filter, the passive elements of ...
    • Simulation and analysis of electric field strength at ground level as basis for lightning hazard warning 

      Nur Aishah, Rahmat (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      To fulfill the project requirement for the fifth and six semester, a standard report was produces according to standardize documentation this documentation is written to help student to understand the requirement and ...
    • Design of impulse current generator for surge protection device testing 

      Muhammad Hilmi, Mazelan (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-04)
      The behavior and performance of surge protection device under the application of lightning impulse are different from that of single stroke test. Since the surge protection device is the most commonly use as a protection ...
    • Sensitivity of adjustable speed drive to voltage sags and solution 

      Nur Atikah, Zainol (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-04)
      This project was discuss a about sensitivity of adjustable speed drive to voltage sags and solution. This project is presence the three phase (balance or symmetrical) and single phase ASD and the result from the experimental ...
    • Design of power factor correction circuit applied in inverter 

      Nasimah, Mohd Zain (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      The need to keep EMI emissions by electronic power supplies below the limit specified by international standards have dictated that any new power supply design must include active power factor correction at the front end. ...
    • Development single phase full bridge controlled rectifier 

      Muhamad Yusri, Ishak (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-06)
      Regulation of direct current (DC) voltage has already become important in many applications across wide range of industrial sector. This Project, generally, is about designing, simulation and hardware implementation both ...
    • Artificial Bees Colony (ABC) algoritm technique in Economic Dispatch (ED) problem 

      Quah, Chee Hean (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011-05)
      This project studies a method that Artificial Bees Colony (ABC) algorithm in solving the Economic Dispatch Problem (ED) with transmission losses by minimizes fuel cost and also controls the generator limit. ED problem ...
    • Design and optimization of solar power system by using homer software 

      Mohd Radhi, Musa (Universiti Malaysia Perlis (UniMAP)School of Electical Systems Engineering, 2011)
      In an era of high energy prices, many people are looking to use alternative sources of energy. The alternative energy sources are the pollution free, friendly user, their availability is free and can be renewable. From a ...
    • Study of a single phase bridge fully controlled rectifier 

      Ling, How Kiat (Universiti Malaysia Perlis (UniMAP)School of Electical Systems Engineering, 2011-05)
      An electric power can be converted from one form to another form by using power electronics devices. The function of power electronics circuits by using semiconductor devices as switch is modifying or controlling a ...
    • Stepper motor control using pic microcontroller based on light intensity 

      Lau, Aik Leng (Universiti Malaysia Perlis (UniMAP)School of Electical Systems Engineering, 2011)
      These days the engineering system is an important part for a construction site and machinery to save the energy such as man-power. A lot of machinery types have been applies to saving times, money and power energy. One of ...
    • Design buck converter for 12Vdc to 6Vdc 

      Mohd Safarizal, Yaacob (Universiti Malaysia Perlis (UniMAP)School of Electical Systems Engineering, 2011-05)
      A switched mode power supply (SMPS) or switching regulator, efficiently converters a DC voltage level to another DC voltage level, via an intermediate magnetic (inductor) storage or transfer stage, such that a continuous, ...
    • Design and development of 100 w AC-DC flyback converter 

      Mohd Saufi, Jana Aksah (Universiti Malaysia Perlis (UniMAP)School of Electrical Systems Engineering, 2011)
      This project basically is to design, built and develop 100 W AC - DC flyback converter. This circuit is design by using PSIM software. It is design for universal AC line input and the circuits will be test under various ...