Search
Now showing items 1-10 of 18
Tunneling characteristic of voltage sag in power system
(Universiti Malaysia Perlis (UniMAP), 2011-05)
Voltage sags are the short durations in root-mean-square (RMS) rated AC voltage occur during faults may cause miss-operations to the customer’s equipment and loads of power system and recognized as the most important power ...
Sensitivity of adjustable speed drive to voltage sags and solution
(Universiti Malaysia Perlis (UniMAP), 2011-04)
This project was discuss a about sensitivity of adjustable speed drive to voltage
sags and solution. This project is presence the three phase (balance or symmetrical) and single phase ASD and the result from the experimental ...
Optimal allocation and fault analysis studies of DG
(Universiti Malaysia Perlis (UniMAP), 2011-04)
This project present the optimal allocation and fault analysis in order to study the
improvement of DG in distribution system. To obtain the maximum benefit of getting the
optimum size of generator, AIS technique and ...
Computer aided education on power cables
(Universiti Malaysia Perlis, 2008-03)
This final year project presents a development of computer aided education on power cables that used to distribute electricity. With urban growth, power cables became moreover increasingly necessary to replace some of the ...
Analysis of unsymmetrical fault
(Universiti Malaysia Perlis, 2007)
This project is to analyzed of unsymmetrical fault with using the software named Mi Power. In this case of the project we should identify types of fault when fault occurred
whether they are Single Line To Ground, Line To ...
Over current protection simulation for voltage sag in power system
(Universiti Malaysia Perlis, 2007-03)
Voltage sags have become one of the major power quality concerns in recent years facing customer. Characteristics of voltage sags caused by faults in transmission and
distribution networks depend on the over current ...
A study of neutral currents in three-phase distribution network with non-linear loads
(School of Electrical Systems Engineering, 2007-03)
Neutral currents are produce by non-linear load. Excessive neutral current can caused a lot of problem to the system. Beside, the third harmonic is the predominant component on the neutral. The total harmonic distortion ...
AC load flow calculation of power system
(Universiti Malaysia Perlis, 2007-05)
This final year project presents the AC load flow calculation of power system by using the Delphi 7 as the development tool to develop the project. Delphi is a completely a
new program with new graphical user interface ...
Application of optimal reactive power dispatch using evolutionary computation for IEEE 30-bus test system
(School of Electrical Systems Engineering, 2007-05)
This project is concerned with application of evolutionary programming (EP) to optimal reactive power dispatch and voltage control of power systems. Practical implementation of the EP for global optimization problems of ...
Contactors and relays susceptibility to voltage sags
(Universiti Malaysia Perlis, 2008-03)
A contactor is electrically controlled switch used for switching a power circuit
and activated by a control input which is a lower voltage or current than that which the
contactor is switching. While a relay is an ...