Browsing Mohd Arif Anuar Mohd Salleh, Associate Professor Dr. Ir. by Subject "Powder metallurgy"
Now showing items 1-5 of 5
-
A comparative study of solder properties of Sn-0.7Cu lead-free solder fabricated via the powder metallurgy and casting methods
(Syscom 18 SRL, 2013-07)The properties of Sn-0.7Cu solder bulk prepared via the powder metallurgy (PM) method were investigated and compared with solder bulk fabricated through casting. Distinct microstructures were observed in both PM and casting ... -
Intermetallic compound formation on solder alloy/cu-substrate interface using lead-free sn-0.7cu/recycled-aluminum composite solder
(Scientific.Net, 2012-12)Feasibility of using recycled-Aluminum (re-Al) as reinforcement particulates in Sn-0.7Cu is assessed by powder technology method, whereby re-Al particulates are produced from discarded aluminum beverage cans. This paper ... -
Mixing optimization of Sn-Cu-Si₃N₄ via powder metallurgy route for composite solder fabrication
(Trans Tech Publications, 2014)The aim of this study was to optimize the mixing process of a composite solder fabricated via powder metallurgy route, before details study were conducted in the next stage. Powder of Sn, Cu and Si₃N₄ were carefully weighted, ... -
Non-metal reinforced lead-free composite solder fabrication methods and its reinforcing effects to the suppression of intermetallic formation: short review
(Trans Tech Publications, 2013)To increase the solder joint robustness, researches and studies on composite solder carried out by many researchers in an effort to develop viable lead-free solders which can replace the conventional lead-based solders. ... -
Research advances of composite solder material fabricated via powder metallurgy route
(Scientific.Net/Trans Tech Publications, 2012-12)Researches and studies on composite solder have been done by many researchers in an effort to develop viable lead-free solders which can replace the conventional lead-based solders as lead is considered as toxic. Solder ...