Search
Now showing items 1-10 of 10
Microstructure and in-vitro test bioactivity behavior of Co-Cr-Mo (F-75)/hydroxyapatite in phosphate buffered saline solution
(Technical University of Košice, 2014)
Cobalt based alloys were the first metallic materials successfully used in orthopedic applications. However, these alloys are bioinert, it is necessary to make them bioactive in the human body to improve their application ...
Different concentration of Al(No₃)₃ In Zro₂/Al₂o₃ double layer coating steel prepared by electrolytic method
(Trans Tech Publications, 2014)
Stainless steels, such as 440C steel are commonly used for engineering applications. The high carbon contents of this steel have significantly been attributed to low corrosion resistance properties. Surface modification ...
Effect of anodizing voltage on the morphology and growth kinetics of porous anodic alumina on Al-0.5 wt% Mn alloys
(Trans Tech Publications, 2014)
In this study, the effect of anodizing voltage on the morphology of porous anodic alumina and growth kinetics of anodizing of aluminium manganese alloy was reported. It was found that the increasing anodizing voltage affect ...
Surface morphology and corrosion behavior of electrolytic coatings in different aqueous solutions
(Trans Tech Publications, 2014)
ZrO₃/AI₂O₃, AI₂O₃/Y₂O₃, ZrO₂/Y₂O₃ coatings were applied on SS440C steel substrates via an electrolytic double layer coating process. The effect of these different ceramic aquecous solutions on the surface morphology and ...
Comparison study in consolidation of yttria reinforced iron-chromium composites using conventional and microwave sintering technique
(Trans Tech Publications, 2014)
This research is focused on studying the density and mechanical properties of iron-chromium composites consolidated by innovative rapid microwave sintering technology against conventionally sintered counterparts using slow ...
Cu-SiCp composites as advanced electronic packaging materials
(Trans Tech Publications, 2014)
The demand for advanced thermal management materials such as silicon carbide particles reinforced copper matrix (Cu-SiCp) composites is increasing due to the stringent design requirement in the electronic packaging industries. ...
Characterization of PM Fe-Cr-Y₂O₃ composites prepared by microwave sintering technology
(Trans Tech Publications, 2014-01)
This research is focused on assessing the feasibility of the new and innovative microwave sintering technology for fabricating iron-chromium composites prepared via powder metallurgy route. Accordingly, the microwave ...
Characteristic and corrosion studies of rare earth (REE) based anodizing on AZ91D magnesium alloy
(Trans Tech Publications, 2014-01)
Oxide coatings on AZ91D magnesium alloy were prepared using anodizing technique with 10mA/cm2 current density for 5 minutes in electrolyte containing Mg (NO₃)₂ with NaVO₃ as an additive. The corrosion behaviors of different ...
Thermal expansion behavior of the electroless copper coated Cu-SiCp composites fabricated via the conventional powder metallurgical technique
(Trans Tech Publications, 2014-01)
The introduction of the metal matrix composites as the advanced electronic packaging materials is highly anticipated because their thermal properties can be engineered to match those of semiconductors, ceramics substrates ...
A simple one-step anodising method for the synthesis of ordered porous anodic alumina
(Taylor & Francis, 2014)
Porous anodic alumina (PAA) has been produced on aluminium substrate by single-step anodising at 50 V in 0.3 M oxalic acid at 15°C for 60 min. The highly ordered pore and cell structure was achieved by subjecting the PAA ...