Search
Now showing items 1-6 of 6
Simulation of flux distribution and loss calculation at three-phase transformer core with the mix 60o-45o T-joint
(Universiti Malaysia Perlis (UniMAP), 2010-10-16)
This paper describes the result of simulation of flux
distribution on 100kVA 3phase distribution transformer
assembled with 23o T-joint and mitred lap corner joint with
stagger yoke and limb for one lamination. The ...
Flux simulation on 100kVA three-phase transformer core
(Praise Worthy Prize S.r.l., 2010-06)
This paper describes the simulation of flux distribution on 100kVA 3 phase distribution transformer assembled with 60°-45° T-joint and mitred lap corner joint with stagger yoke and limb. The core that being used is 3% ...
Predicting the localized flux distribution in three phase induction motor between different stator slot size
(Institute of Electrical and Electronics Engineers (IEEE), 2011-06-06)
A three phase induction motor differences of stator slot size is investigated in terms of its localized flux distribution. The search coil induced voltage method is used to analyze the flux distribution in the stator core. ...
Predicting an investigation of flux distribution in three phase induction motor stators by using different stator slot sizes
(Universiti Malaysia Perlis (UniMAP), 2010-09-16)
The predicting of different stator slot sizes on flux
distribution in three phase induction motor is
presented. For both stator models, the maximum flux
density is found near the tooth tip and minimum
towards the outer ...
Measurement of overall power loss and flux leakage in M4 grain-oriented silicon iron assembled with 45o T-joint of three phase transformer core
(Institute of Electrical and Electronics Engineers (IEEE), 2010-06-23)
In this paper, the result of an investigation on the effect of using M4 Grain-Oriented Silicon Iron core material to the 100kVA three phase distribution transformers has been analyzed. The investigation includes the variation ...
Analysis flux on transformer core lamination assembled with mix between 60o- 45o T-joint using 2DFEM
(Universiti Malaysia Perlis (UniMAP), 2010-06-02)
This paper describes analysis 2DFEM on 100kVA 3phase distribution transformer assembled with mix between 60-45 T-joint and mitred lap corner joint with stagger yoke and limb for one lamination. The simulation involves the ...